How do I get a steal band for my Aquaswiss Trex watch?

Searches related to how to remove links from a watch hope this helps you..

how to remove links from a watch michael kors
how to remove links from a watch without pins
how to remove links from a watch without tool
how to remove links from a watch band with arrows
how to remove links from a watch band
how to remove links from a watch bracelet
how to remove links from a watch band without tool
how to remove links from a watch without arrows

You needs watch band kit to depress the band retaining pins.

You can call Tag Heuer and order a new band or you can try online sources such as ebay who sometimes sell them at a lower price.

Thank you for contacting FixYa.<br /> Very difficult to find certain odd brands such as Aquaswiss. You wil have to contact them direct at :<br /> <a href="http://www.aquaswisswatch.com/Scripts/contactUs.asp">http://www.aquaswisswatch.com/Scripts/contactUs.asp</a><br /> <br /> Best regards,

How you go about putting in the extra links to make the bracelet fit your wrist?
Here's a link that may help, you'll need a couple of tools,
http://www.pmwf.com/Watches/WatchSchool/WS%2014%20How%20to%20Resize%20Common%20Bracelets/WS%2014%20How%20to%20Resize%20Bracelets.htm

In addition to the Pin there is also a small inner "locking" collar about 2mm long that fits into the center section of each link.

I did not notice this collar at first and it fell to the ground when I removed the first link. Without this piece the Pin's will just slide through the links with no locking mechanism.

It fits neatly into the inner portion of the link directly opposite the arrow that shows the direction of removal on the band.

there are little pins holding them in place pop them ou and add or delete couple links.

VSNDESIGNS SAYS:

You should first try to adjust the band at the Clasp first. The clasp has three holes that you could easily move your band up or down into. If you need to remove one or more of the links, try the following.

http://www.fixya.com/support/t315141-adjust_band_aquaswiss_trax_watch


http://www.rgmarchitect.com

go to any jewelery store cheers

Warning: This is if you don't have any professional watch tools. And I definitely recommend you taking it to a jeweler first.

That being said...

I was able to adjust my band by using a small nail and a pair of needle nose pliers...and Krazy Glue or Super Glue (last warning...you really should take it to pro)...

1. Push the any one of the pins that holds the wristband together until you see it protrude from the other side. While applying pressure to the pin, quickly grab it from the protruding side with the needle nose pliers and pull off the metal cap from the pin.

2. Note you will notice that the pins are actually 2 pieces! They are not screwed together and it makes for a pretty poor design since, one the pins are taken out and then replaced after taking out the appropriate links... they tend to get loose and you will lose that tiny metal cap that holds the pin in place.

3. A professional will have a clamp that is small enough to press these two pieces together. But even that is precarious. I strongly recommend that you carefully apply a drop of crazy glue on each end of the pin, after you are finished.

Final note: I was luck to have spare pins from the links I removed to replace the pin that worked out of its cap. That little sucker is lost to the watch gods. Have fun! Also... you can make final adjustments at the 3 pin location at the wristband release.

Hope this was helpful!
vsndesigns

http://www.rgmarchitect.com