Bad color on sony kv-36fs16

THERE ARE ADJUSTMENTS TO THE VIDEO DRIVE THAT CAN CORRECT THIS PROBLEM/THEY ARE IN THE SERVICE MENU. WITH THE POWER OFF, PRESS MENU-5-VOL+ POWER THE SET WILL COME ON IN THE SERVICE MODE. STEP THREW THE MENU ITEMS UNTIL YOU GET TO RED/GREEN/BLUE DRIVE THEN ADJ. TO BALANCE THE COLORS WHEN DONE PRESS MUTE TO STORE THEN POWER OFF ON THE FRONT OF THE SET OR IT WONT SAVE.

Try adjusting the brightness on the monitor

When ever a tube starts to short or is shorted set always will have over bearing drive lines then shut down like RED if it was bad, set would come on long enough for red lines across set then shut down this is the same with all 3 tubes.Also if you think it might be green tube disconnected green CRT board on neck of green tube if set comes on and plays then it is green tube do all 3 tube this way one at a time this will tell you if you have other problems.

This issue occured under magnatic field it will remove automatically after some time.
the second option is, you call a Repairman and told him to degauss
the screen after degausing the screen your issue will be fixed.

first try adjusting the color-tint on the menu if this does not solves the problem you have a failing proyector and has to be replaced

Try turning down (off) the color during such an episode. If the image is tinted pink or green instead of black and white when you do this,you have either an intermittent short in your CRT (tube), which is terminal,or a gun drive problem, which may be repairable. If you're feeding it component instead of composite signal,it may just be a bad connection of the B-Y cable.

CRT is bad,I just stripped one for re-cycle yesterday.....T.

Definitely bad picture tube==not worth fixing......T.

Most likely a bad CRT,not worth fixing......T.

try adjusting the convergence. good luck and happy valentine!