Forgot ID password of my ir2020 canon photocopier

How to reset E000, E001, E003, and E007
Canon IR2016, IR2020
Enter the service mode by pressing "additional function" key, "2" and "8" keys in that order. SSSW will display. Press "OK" key.
Change Bit switch 1, bit 0 (might display as the first one on the left using number keys) status, (change 1 to 0 or 0 to 1).
Press "OK" then Press "Stop" or "Additional Function key" to end service mode or restart the machine.
Canon IR2270/IR2870/IR3570/IR4570/IR5070/IR5570/IR6070/IR6570
Enter the service mode (Press "Additional Function" key, Press "2" and "8" simultaneously, press "Additional Function" key again).
Go to COPIER----FUNCTIONS-----CLEAR----ERR. Here you can reset all error codes on by one.
Canon IC-MF6530/6550/6560/6580
No reset procedure is required, replacing the fuser is the only repair.
Canon D860 series
Press Additional Function key and the "#" key in that order. Go to Printer (number 7), select "Set", Select "Printer reset" and press "set".
Canon Printer Support Phone Number

check link below
Canon copier Jamming Fix your Canon Copier
pree helpful button

E 808 0000 Fixing drive circuit failure
- The heater does not turn on. - A fixing drive motor failure was detected.
- Check the connector of the fixing film unit. - Replace the fixing film unit. - Replace the fixing drive motor. - Replace the DC controller PCB. - Replace the power supply PCB.

I have a Canon photocopier NP 6030. Problems on my machine, the display panel is written ENTER ID Number ......., How does the solution sir? Listen Read phonetically

If you know the password, then under user mode, i think system sett., must be option for department id management where you can change passwords.

If you dont have pass, you can do clear all under service mode ( * 2 8 * ) if canon changed service mode, like on some series, you can try MENU and #.

Hope that helped

How to clear the erroe : 0xf0af8005

go into service mode additional functions button hen press 2 and then 8 keys then press additionl functions button, then scroll through until you see clear press enter and scroll through until you see passwod clear then restart machine and be no administrator password then

Hello sir; According this particular model,the waste toner box comes with drum unit, for another word if waste toner box is full you have to replace whole drum cartridge.

Under service mode *28* find the clear all and OK, after that you shouldnt have any pass required, but you need to set the IPadress, and your preferd sets.

BD detection PCB failure
The BD detection PCB is faulty.

- Check the connector of the BD detection PCB.
- Replace the laser scanner unit.
- Replace the DC controller PCB