Sir,
How to connect power led ,HDD,Reset,power SW cables in Intel Mother board series D815EEA2
Go to the site below. Its a manual for the 800/i65GV group. Go to page 67 and zoom in. You'll get a nice look where everything goes. Two rows of pins. Upper row and bottom row. Real close to each other. Do not place connectors up to down. Connect only left to right.
The reset connector has two pins. One will be white or black. These are - grounds. So connect it to the bottom row onto the most right two pins. Moving to your left. Skip one pin. Take the Power Switch a two pin connector. Remember Black & White is ground & ground goes to your right for both rows of Mb pins.
http://dlsvr03.asus.com/pub/ASUS/mb/sock478/p4p800/e1324_p4p800.pdf
Go to IDE_LED next. Its the last two pins towards your most left of the bottom row of pins. Move to the upper row & the power LED. Same as the bottom row keping the grounds to your right. Lastly is the speaker. Its connector holds four pins but you only use two. One in each end.
Good luck & please vote....
The manual is here:
ftp://download.intel.com/support/motherboards/desktop/d815eea2/a4639902.pdf
Starting at Pin 1 (Hard drive LED) is positive + & pin 3 is ground -. Next, Power LED, Pin 2 is + & pin 4 is ground - .657 views
Usually answered in minutes!
do not know how to connect m/b sw,turbo led,power led,h.d.d led,reset sw leads to motherboard ms6178 ver 1.1 need to know what order they go in and how to connect
elitegroup p4s5mg/gl
My Speaker, HDD Led, Power Sw, Reset Sw, Power Led are all disconnected and the board doesn´t have any labels, What can i do?
×