My hp 2480 has an error message 10.1004 - HP LaserJet 2840 All-In-One Printer

This means the low-level part of the operating system is corrupted or missing. Simply try reloading the OS by putting the CD into the CD drive. If it does not allow an OS reload or if it fails, most likely the flash ROM which holds the basic part of the OS has been zapped and will require service. You can also try to replace the internal button battery inside that retains the memory.

This issue comes up when Carousel misalignment realigning &cleaning will resolve the issue.

If your OS is WinXP look at this link

follow the link to hp
http://h10025.www1.hp.com/ewfrf/wc/documentSubCategory?tmp_rule=53851&tmp_task=solveCategory&lc=en&dlc=en&cc=us&lang=en&product=3811337
and select either msi or installation error for solution.
Mark

This problem is related to Firewall settings. If I guess right, you've installed the Outpost Firewall with the Hp Software. Look at the right-side of the taskbar, you'll see a light-blue icon of Outpost Firewall. Right-click the icon and select "Disable". Now, open "My Computer" > double-click C:\ drive > Program Files > Agnitum > Outpost Firewall > locate and open "machine.ini" > Notepad will open up, now locate the line in the notepad text "EnableContentHandler=True", now replace the "True" with "False", and save the file.
Now re-enable the Outpost Firewall from the Taskbar. You'll be able to scan now.

Good luck.

Thanks for using FixYa.

Hi. The STOP 0xC000021A error occurs when either Winlogon.exe or Csrss.exe fails. When the Windows NT kernel detects that either of these processes has stopped, it stops the system and raises the STOP 0xC000021A error. This error may have several causes. Among them are the following:

• Mismatched system files have been installed.
• A Service Pack installation has failed.
• A backup program that is used to restore a hard disk did not correctly restore files that may have been in use.
• An incompatible third-party program has been installed.

Booting the computer to its Last known good configuration will resolved the issue. Please see procedure below:

Turn of the computer
Keep on tapping F8 key the moment you press the power button
You should be getting a advanced boot screen
Select Last known good configuration from the selections then hit enter
Computer should be booting up by now to windows

All the best!

Here are some great source where will will get any kinds of HP,ACER,DELL and COMPAQ laptop Solution and any kinds of Driver download.

» Hp Laptop's Solution
» Compaq Laptop's Solution
» Acer Laptop's Solution
» Dell Laptop's Solution
» Toshiba Laptop's Solution
» Asus Laptop's Solution

» Hp Driver's Download
» Compaq Driver's Download
» Acer Driver's Download
» Dell Driver's Download
» Toshiba Driver's Download
» Asus Driver's Download

armania61

Look for, and scan, the "Enable Override" barcode in the Intermec Trakker Antares 2400 Family System Manual, available in the manuals section of intermec.com.

Normal 0 Normal 0 Driver could be corrupt.
Disconnect the printer or at least be sure it is turned off. I'd do both and reinstall the CD software program that came with the printer. When the software program asks you to connect the printer to the USB port, do so and it should again work properly.
Hope this helps. Bud

You Have To Install The Intel Chipset Drivers First As It Contains The Microsoft Bus Drivers