It doesnt turn on just the blue light on the wheel

If it is steady blue then it is ready to be found by your phone. If you see the headset in your phone remove the pairing and repair again. You should hold the multifunction button after turning on until it goes steady blue if you aren't getting a steady blue light in order to pair it.

It could be dying... You can always buy an external camera and attatch it via usb port.

Bought my wife one at JC Pennys, Computer doesn't recognize it and no red light ever showed up however a blue one does also the website listed in the paperwork www.sakar.com doesnt even list the swagger mp3 player

Hi,

Red is a failure warning but if it only hasppens with the usb plugged in it's mostly likey a failure in the IDE/SATA to USB conversion board.

Take the drive to your local PC shop, ask the techs there to pull the hard drive out of your phantom and test it in a new enclosure. If it works there, buy the enclosure, if it doesn't reply back and let me kow your Country, State and City and I can recommend a pro to look at the actual harddrive if you need files recovered from it.


Hope this helps FixYa

ok..idk if this will work but it might...first turn off the sansa...then turn the hold switch on (it should turn red). hold down the record button on the side of the player..then while still holding that hold the power button down...but keep holding them untill a screen shows up saying something about recovory mode..itll say to plug in the usb..u could do that..idk it that will work..it it doesnt instead of plugging in tthe usb in the computer..wait about 15 seconds after the recovory mode screen shows up and then hold down the power button for about 15-20 sec...then itll go all black (including the blue light) press the power button again like u would to turn it on...and everything should be back to normal..hope this helps...:)

I also have this model. A few months ago, when I turned on the tv, it told me my lamp was in need of replacement. just yesterday, my tv did the same as you....the blue light flashed and then the lamp light kept flickering. All I can say is your lamp needs to be replaced.

If that is the case your system need to check the battery for fault and does it happen with the power source too i fthe same problem check your processor fan if its bad when you on the system and is not blowing that might have cause the processor itself to get bad you will have to change this ones and then your system will be ok right rate this solution.

there can be 2 problems:

1) VIRUS INFECTED

2) DLL file is infected

Plug it into another computer if possible, clear ALL files on it.
You must of been sending something to it when you flicked the switch, they would normally go off straight away.

(Backup on the other computer first)

If this does not work then you may want to see if you can see a usb stick in your USB ports. If you can it's a fault with the harddrive, nothing else you can do.

When you dropped it, the batter became loose from the contacts inside, therefore it doesnt charge, but lights up when you connect it to the computer. Remove the 4 screws on the back, then take out the battery and then press it in firmly. Charge the device for about 2 hours. Please add to the question for additional assistance. Best of Luck.