RCA F27242GY Had a power fluxuation this morning while the TV was on.  When the power came back, the tv would click 3-4 times when I tried to turn it on.  I unplugged it for a few hours and tried again, same problem.  Any idea about a solution?

If this particular model does not have your typical RCA jacks in the front or back, Yes you will have to purchase an RF converter box. This is a common problem for the older conventional TV. Visit your local electronic store. Thanks for asking and show a few hands of support!

Using the remote click on the menu and find audio

check each area under audio and change one at a time til you get the sound back. Keep notes on what u r doing so u don't make matters worse. J.

My experience with the RCA F27242GY 27" TV going on and off is as follows:
Where the coaxial cable connects at rear and the base of the TV chassis part # 15062-57A is loose.

there is a problem with the power supply..the regulator...change the regulator...

por favor necesito codificar control remoto modelo rcr412si1612p para el televisor rca f27242gy

First did you try all the codes. Some codes do not activate that function to work with the TV. Second what type of TV is it . If it is a combination tv - vcr - dvd these are the hardest to get to work with a universal remote . good luck

Sounds like a bad flyback transformer . Whats the model # . These are common problems with those sets . Does it click then clicks right back off ? If so this is your problem . good luck

u have a short in the power supply section

Hey Jim, The high voltage protection circuit has gone out on the D-board and will need to be replaced. The fuse to the power supply is probably fine. A good repair tech shouldn't charge over $125 for this and it only takes a couple of hours. Let me know if I can be of further assistance.

there is no reset button on any tvs that stop in 1980s when they no longer used tubes in chassis,s now the only tube is your picture tube. you probly have a shorted hori out put transistor.