Finding a replacement protection screen for a mitsubishi tv modle # ws-65813

If its the outer protective screen that u need I have one. I didn't like the glare it provided me with so I took it off. Email me remarkable14u at yahoo dot com.

Mitsubishi is about the only one that MAY have that but it is no picnic to replace.

need resolder bottom of boards

Someone first needs to check the module inside to see if their has been fluid leaking at least get it looked at this is a great tv designed to last alot longer then the new ones

try to look at its circuit board and look for some cold solder

Please help

you can get the service manual and detailed instructions on that repair by going to the following link.
http://servicemanuals.vstore.ca/

the TV to look it over is around $50

there are 4 caps that need to be replaced. http://chrisandnat.com/projects/blinkingtv/blink.htm

You have a common problem in the DM (Digital Module), more specifically the DM power supply. There are four electrolytic caps in that supply 16v/1000uf that are bad and likely buldged from heat stress. Replacing these caps and the E2P module, a small stand-up board further back on the main DM board should restore normal operation...
You might be lucky enough to have a tech come out and simply replace those caps in-home. It's not a really big job for a qualified tech.
Hope this helps!
Bill