My BF162 runs with the door open. I also cannot

Lets try the following hope this works

1.- unplug the appliance, isolate it from the electric supply.
2.- Remove the kitchen unit plinth and check inside the inspection panels below the door to see if there is water in the base.

If there is, sponge it out and then try the machine again.

Was this helpful?

When you keep the button pressed for a few seconds the lights go off, this resets the dishwasher. Then press the p button again to the program you want 1st light is heavy soil 2nd light is normal soil, 3rd light is eco wash, 4th light is rinse. At the end of the cycle the program light you have selected will flash.

Open the bottom panel of the washer and see if it is full of water, if it is drain it away and clean all of the filters inside the washer and reset.

take out diswasher, tip it backwards and drain out water. make sure that salt resovoir is on tight and there are no leaks from the arms

hi
sounds like you have a heater problem,check connections on your main module behind control panel if all appear ok check you heater for open curcuit.

You can cancel the programme at any point by holding down the last button on the right hand side for about 10 seconds until it clears (its the same button you use to get it going again when you open up the door).

after the 20 seconds does it restart

2+4 - Heating circuit not working. Possible causes - Heating element, connections, timer relay.
Maybe too late a response.

Ian

consult manual under troubleshooting.
if no manual, or if it does not address this, consult service center.

one likely cause you can try first is to disconnect it from power via the cord or a breaker. after a brief period, it may reset itself.
otherwise you likely have a logic board issue.

logic boards seem to be very vulnerable in dishwasher environments. the type of issue you have is very common among most brands. don't feel alone.

good luck
mark

Most common reason is that the lower spray arm splits on the seem and sprays water under the door, to proove if it is this remove lower spray arm and run through program if no leak fit new arm. Regards Advisor