At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Someone has accidentally pressed some buttons and locked you into test mode. To get out of it you need to press start, the display should go daft. Press start again and the display should settle down. Now press the on/off button and the start button at the same time and hold them down for a few seconds until the display shows d-end or d-off. Your machine should now work.
My list for nearly all of the Indesit (Hotpoint, Ariston) washers suggests there is a fault with the motor triac, the bit that controls the motor speed, sorry ;-0(
If this has assisted you please consider a 4 thumbs up for the rating.
Thanks and good luck!
John C
Remove the lower rear panel of washer, locate and remove the large black hose fastened to bottom of drum.
Remove and clean plastic filter inside the hose.
Reassemble and test for leaks.
Have some cloths ready to wipe up water from hose.
the f-01 error code on your hotpoint all in 1 washer/dryer is a short circuit code for the motor. the only way to clear the code is to have a service tech come and inspect the reason for the error.
Hotpoint’s are designed to go into test mode when the start button and
the on/off button are pressed at the same time. If you are stuck in
Test mode, simply hold the start button down until it comes out of test
mode, then hold both the start buttons and the on/off button down until
you see ‘D:end’ (or similar message)."
×