Maytag quiet series 300

Is sink drain line clogged?
Disconnect drain line at sink tailpiece and lower down to see if water inside dishwasher drains.
Call serviceman to clear clog in dishwasher hose, or repair dishwasher pump motor.

If you need further help, I’m available over the phone at https://www.6ya.com/expert/gene_9f0ef4df2f9897e7

replace the door latch and the handle check to see if the console loops that hold the latch are broken if so replace the console

Hold down the heated-dry button for 3 seconds and the light will clear.

This may be coming from your garbage disposal. You may not realize that residue in the disposal will seep back into the dishwasher line. Make sure the hose to the dishwasher is higher than the port where the hose enters the disposal. This will work even if you don't have a disposal. Many people make the mistake of lying the discharge hose from the dishwasher lay flat. It must go up to come down. That's why dishwashers have pumps. Hope this helped !

Maytag Quiet Series 400 dishwasher model MDB7601AWS

Go to;
http://shared.whirlpoolcorp.com/product_literature/search_results.jsp?searchTerm=MDB7601AWS&siteCd=MT_EN_US

and clink on any manuals you want.

MY DISHWASHER KEEPS RUNNING, IT IS A WHIRLPOOL GOLD QUIET PARTNER IV

Check for foreign objects like glass or plastic at the grinder blades. Some dis assembly will be required. See appliancepartspros.com for diagram.

check the float switch on the righthand side on the bottom in the corner it should click and move freely

Maytag Quiet Series 300. The lights flash in sequence starting from the outside traveling inward. The timer counts backwards from 50 to 1. Then the sequence starts over. and continues over and over. I'm able to clear it when the time reaches 1 or 2. It stays off for a while (3-4 hours) then starts over. I can not clear the countdown until it reaches 1 or 2. After I clear it the dishwasher will work, but until then, no way. This happens with the door open or closed.

Hi jeffwirch,

I'm Harvey the Master Plumber.

Your problem is: You have a maytag quiet series 300. When it is done with any of the cycles in leaves about 1-2 inches of water in the bottom of the dishwasher. You can manually hit the start button twice and it will go through a 2 minute cycle and pump out the water. You have cleaned the filter inside the dishwasher where it drains and have checked the hose to the disposal and it pumps out fine. It just doen't pump itself at the end of the cycle.

It sounds like a bad control board. It's in the top of the door panel. I don't recomend this repair to the average homeowner. You might consider the Repair Directory to find a repairman.

Feel free contact me again!
Please give me a rating here at fixya.com before you sign off
Thank you,
Harvey your Master Plumber