Question about Robot Coupe MP600 750 Watts Hand Mixer

1 Answer

Blade will not turn

Power switch turns on motor but blade will not turn

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 143 Answers

Motor will hum but no blade turn if bottom seal worn and material leaks into shaft. Rekove drive head and try turning shaft if nio go dissasemble entire unit ,clean and service, replace seals

Posted on Sep 20, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

60 qt Hobart mixer H600T makes buzzing noise and won't spin. The hook seems blocked, can't spin it manually. Opened the top part and everything seems fine. What can it be and how to fix it? Thank you


call in an electrician as it may be the start/run capacitor for the motor ( indicated by motor humming but not running)
the gearing will make it very difficult to turn the blades by hand as the motor will be spinning at either 1400 rpms or 2400 rpms down to around 50 rpms for the blades

Jun 30, 2016 | Hobart Food Mixers

1 Answer

Shaft does not rotate motor workink


My Bamix stopped working--no shaft movement and loud motor noise (think disuse caused motor lubricant to thicken). Propped it upside down and put drops of quality machine oil at seam where narrow blade shaft enters larger shaft (in center of curved guard). Probably not necessary, but added a few drops where large shaft enters handle. Oil slowly seeps in. Attached a blade to manually turn for oil distribution. Did this periodically over several hrs. Turned on low speed and it gradually returned to full speed capacity.

Oct 25, 2013 | Bamix De Luxe Hand Mixer

1 Answer

I have a hobart mixer 80 quart .The motor makes a noise and would not start. It only starts if I turn the shaft and turn the on switch at the same time


Most motors of that type have a capacitor that puts the stator out of phase with the rotor. They are capacitor start induction run motors. These also have a centrifugal switch inside near the end ot the shaft to put power to the start winding for a split second to determine the direction of turn and to increase horsepower until it is up to speed. So if it fails to start either the centrifugal switch needs cleaning (or replacement if damaged) or the capacitor needs replacing to give it its original power, or the start winding has failed from overheating. There may be a thermal cutout on the start winding that may need to be replaced if it did overheat. If the start winding burned then the motor would require rewinding or replacement.

Oct 10, 2013 | Hobart M-802 80qt Dough Bread Bakery Mixer...

1 Answer

Model km25g


It sounds like your problem may be with the motor itself rather than the planetary, or with the board the motor switch is attached to. I think you need to test whether the motor is getting power when the switch is moved on. if it is, the motor may need to be replaced. If the switch is faulty, replace the board the switch is attached to.

Apr 29, 2012 | KitchenAid 32685 Mixer

1 Answer

One of my blades is stuck and I can't engage the release


Make sure your Beater can slip in and out of the Beater Shaft
easily. Do not force the beater onto the Shaft if the shaft is bent.
If it cannot be removed easily by hand, use a soft rubber mallet
(not a steel hammer) to slightly tap the beater so it can be moved
up and down the shaft or from side to side. Then you can easily
turn the beater left and remove it from the shaft.

From Kitchenaid Manual:
To Attach Flat Beater, Wire Whip, or Dough Hook
1. Turn speed control to OFF.
2. Unplug stand mixer or disconnect power.
3. Tilt motor head back.
4. Slip beater onto beater shaft and press upward
as far as possible.
5. Turn beater to right, hooking beater over pin on shaft.
6. Plug into a grounded 3 prong outlet.

To Remove Flat Beater, Wire Whip or Dough Hook
1. Turn speed control to OFF.
2. Unplug stand mixer or disconnect power.
3. Tilt motor head back.
4. Press beater upward as far as possible and turn left.
5. Pull beater from beater shaft

Jul 19, 2011 | KitchenAid KSM150PS Artisan Series Stand...

2 Answers

The /blade doesn'treach the bosttom of the bowl what to do


If the blade is locking in correctly and not loose then that is how it is supposed to be. Remove blade and reseat it to be sure.

Jan 11, 2011 | KitchenAid Food Mixers

3 Answers

Blade won't release from mixer


Try to push up while you turn the blade. Don't be afraiid to turn hard.

Dec 30, 2008 | KitchenAid K5SS Heavy Duty Commercial...

1 Answer

MUM 6622 Motor Has voltage to it but will not run!


I have the same problem after running for a while, turning off then back on. It will not start. I found the heat sink fuse in the motor was burning out. When the motor gets hot then turned off, no fan and the heat build up enough to melt the heat fuse. It would be an easy replacement if I could find where to get them. To find it on the motor, look at the wire going from one corner of the motor to another, but looks like it goes into the motor in between. Pull on that going into the motor to lift the heat fuse out.

Aug 27, 2008 | Bosch MUM6630 Universal Series Stand Mixer

4 Answers

Bamix slowdown - repair service anywhere out there?


click on the "contact" link in this website http://www.bamix-usa.com/ there's places in Canada & the US to have them serviced. Through contacting them they'll give you the nearest service area.
Good luck, love my Bamix!

Aug 11, 2008 | Bamix De Luxe Hand Mixer

Not finding what you are looking for?
Robot Coupe MP600 750 Watts Hand Mixer Logo

Related Topics:

426 people viewed this question

Ask a Question

Usually answered in minutes!

Top Robot Coupe Food Mixers Experts

eyecam

Level 2 Expert

96 Answers

myrlanthian

Level 2 Expert

250 Answers

Ravi

Level 3 Expert

1682 Answers

Are you a Robot Coupe Food Mixer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...