Looking for clifford alarm manual,did not use the car for 8 months,the sound on the alarm went,does work ,lock unlock but no sound ,maybe easy repair????any ideea?thx

My best advice is to contact clifford direct and explain your problem normally very helpful.

http://www.informationvine.com/Clifford+alarm+system

The car won't start because the Clifford alarm has a starter interrupt wire where the start wire runs through the alarm system module/relay. The unit then must still be active for the car not to start. If pressing the disarm/unlock button on your Clifford key FOB does not turn the system off, you will after to do it manually. You will need to locate the manual override button installed somewhere in the car that is connected to the alarm system. Turn the ignition switch to "on" or "run" and within 10 seconds press the manual override switch. That will turn the alarm system off and allow the car to be driven normally. I would then take the vehicle to an authorized Clifford or other DEI (Viper) install shop and have them diagnose your apparent problem.

the motor in the drivers door has packed up, you will need to replace this for it to work properly.

im puting a after market alarm on a dodge ram 09 how do u do door locks

Assuming that all is well with the vehicle's electrical system (fuses, etc...), the following should work, as Viper/Clifford uses the "fail safe" method of starter disable, and it only works to lock out the starter when the alarm is functioning properly and in the armed state.

That system has a "starter kill" system. When the alarm is actived, the starter kill is engages, and won't let the starter get voltage from the ignition switch. First thing I'd try is connecting the car's battery while the ignition key is turned to the "on/run" position. Cycle the alarm to arm, then disarm, so that the LED is not blinking. It also may require using the manual override button/switch (with the key on) to reset the alarm. Should start after that.

If all else fails, reconnecting the starter wires back together (they are spliced and running through the alarm via a SPDT relay.

Find where your fuel pump relay is and check for power there. Most alarm tech's and alarm system dis engages the fuel pump at there relay's.

Simple things to check is the fuse first then go for the relay and if everything there is working properly, it could be your alarm may have gone bad or your fuel pump it self.

Good luck and hope this helps

if you unlock the doors via key in drivers door do all the doors unlock . if they do you may have a siezed locking unit

Try changing the batterys in the remotes mate

i just bought a concept 300 but have no dirgram can you point me were i can get one