How to start the self-cleaning cycle in jenn-air sce30600?

There are two reasons for the lock to remain locked. One: the thermostat/wiring failed. This results in the oven's control still believing that the oven is too hot (over 450 degrees) and thus will not unlock. The other possible problem is that the unlock mechanism failed.

You can try to unlock the oven manually. (For some ranges, you can do this from the back of the range.) Please add a comment with the model of the oven/range for more assistance.

I hope this gets you started on solving the problem.

Cindy Wells

Hi,

Below are the details of error code F9...

JENN AIR
'Newer Style' Range/Stove/Oven Fault Codes
Fault : F9
Condition: Door lock safety circuit on power relay board sensed
Replace power relay board

JENN AIR
Range/Stove/Oven Fault Codes
Fault:F9
Condition: Door latch supervisory
Check door lock circuit or replace clock assembly or ERC


Let us know if you want something else please accept the solution.

Thank You for contacting fixya.com

Sorry to read about your problem, I hope this helps you out.

try using an oven cleaner spray... let the range heat up a little..then spray oven cleaner

a new glass top will cost over $600.00 just for the glass.


I have tried to help you. Please help me by vote/rate the response. Thanks If you live in the Denver Area. I can help you out.

I had the same problem... resetting the breaker fixed it for a while but it the problem always represented itself. Replacing the temperature sensor at the rear of the stove finally solved the problem. My problems started after doing a "self clean"

there should be a button a small button that says self cleaning on the oven mines on the side but just look almost 95% of all ovens have this

OK, here's the manual for your Jenn-Air CCE3401 cooktop in a pdf format that you can download and print, for free!

http://shared.whirlpoolcorp.com/assets/pdfs/literature/Use%20and%20Care%20Guide%20-%20CCE3401B.pdf

IF this isn't your cooktop, as that's the model number you entered on this site, requesting help, go to the following link and enter in your model number to get the correct manual for your particular Jenn Air appliance:

http://shared.whirlpoolcorp.com/product_literature/search.jsp?siteCd=JA_EN_US

Hope you find this Very Helpful and best regards!

Did you spill water near/on knobs? if so leave to dry out for 24 hours. If still clicking after 24 hours one of the switches has shorted out and needs to be replaced. You can find which one with a multi meter/condinuity test. Hope this helps...Good Luck

Hi
I have all the diagrams for that model and will gladly send them to you all for free via email. Remenber that the fan will always get gresse and have to be clean, also keep the filter clean.

Let me know were to send the diagrams...Glad to Help!!

Eddie Rentas
Tupper Lake NY

Did you find anything out? We have had our Jenn-aire gas stove for 1 1/2 years and just noticed today that the surface has bubbled in a spot??? I did clean the oven last week.