Just need the wiring diagram for swtich and reset button

I'd probably check the wiring harness on hinge side of driver door. There is probably a protective rubber boot covering, pull the boot back to see wire colors. Look at wiring diagram for your power windows, check the proper wire colors for voltage and ground.
If you want me to try to post wiring diagram, I need year--make--model?
Your owners manual may show you which fuse and/or relay controls the power windows.

there is no release. it can only be moved with the motor. if the swtich is bad you can try to bypass the switch using a battery and 2 wires and get the wiring diagram for the swtich. then if you know what your doing. jump the wires and get the motor to work

1) adjust the REED swtich, clean it, and tight the connector well , see the diagram attached.

2) try after you fix it, RUN the software calibration go under the HOOD the motor with the instruc for to follow the step in s. calibration
God bless you

adjust the reed swtich, see the diagram attached,clean it, and tight very well the connector
2) replace the batteries and clean the contacts battery very well.

God bless you

1) power home. c.breaker tripped reset or blown fuse
2) door switch, test for open or defective replace
3)wires for open, break or burn, repair
4)timer or selector swtich, test for open dirty contacts, loose wires, break or burn, or open switch replace.

God bless you

1) test the button for open or defective.
2) test the relais is open or defective see the diagram , if the relais is not closing the motor will not GO.
3) Test the swtich door is defective or open, this avoid the machine RUN too see the diagram.
God bless you

1) Test the fuse blown, or c.breaker trip, reset.
2) Test the outlet wall, and reset the c.breaker home
3) Test the power switch, for broker or open and replace see the diagram test.
4) Reset the machine.
5) Test the power cord, for break, burn, and loose wires, repair.
6) Adjust the Reed swtich, see the diagram attached.

proceed with this step:
Power from the house
test for some blown fuse or c. breaker reset.
Door switch
if the swtich door if open or defective, will not start the machine see the wiring diagram attached.
Wiring
see for wires, burn, breaker or loose repair.
Timer or selector switch
test the timer, for contact dirty, or corred, clean, and tigh the wires loose see the diagram attached.

you don't need a wiring diagram to fix this, what you do need is to know what to look for. you have two swtichs for your brake light front brake lever and rear. i would start at the front because it is just a push switch. start be unpluging the gang plug for the rh handlebar switch housing has your brake light gone off?? if so you front brake switch isn;t working if not then check you rear switch unplug it from the harness. light off? if so your rear swtich is bad. check into and let me know
Mark

The LEd wires need a wire run from the speaker to the Fuse block in your car. The small Red wire from the LED will be the one that hooks to Swtiched 12 Volts supply on the fuse block so that your Led Turns on when you turn the keyswitch on. The Black wire goes to ground, or to a metal part of your cars body, probably the same point where your Amp is Grounded.

The Octane R10 is a Single Voice Coil or SVC.
AMP+ to Sub+
Amp- to Sub -
Use 12 guage wire.