My digital lifestyles 42 widescreen lcd hdtv won t power on, When you hit the power on button the green light comes on but no picture or sound.

Sharp TV - Flashing OPC & Power Lights - YouTube

? 0:50
https://www.youtube.com/watch?v=BH1OcQ6dIEE
Jul 1, 2011 - Uploaded by Tweetssun
Sharp Aquos TV flashing a OPC & Power Lights in a pattern of 3 flashes, ... Sharp Aquos LC-32D44 - One blink lamp error - Nopicture or sound - Diagnosis ... Repairing Flat Screen TV - Blacked out with blinking red light ...Missing: 32dv22u

Sharp lcd tv power button flashing - HDTV - Streaming Video & TVs ...

www.tomsguide.com/forum/54708-4-sharp-power-button-flashing

Feb 8, 2012 - 7 posts - ‎3 authors
We have owned a Sharp 32" LCD TV for about two years. ... However a quick Bing search shows that the blinking green light usually means a bad power board, which seems ... No picture, no sound, just a black screen and two blinking green ... a cable surge block on the coax where it comes into the house. Sharp lcd tv power button flashing - Digital TV
19 posts
Oct 14, 2012
Sharp hd tv blinking power no picture - Digital TV
2 posts
Jan 7, 2012
More results from www.tomsguide.com
Missing: 32dv22u

Sharp Aquos LC 42DH77: Inverter, Backlight, Power and ...

www.normsweb.com/tektips/42dh77.shtml

How many hours has the tv been used ... approx... as this will reveal further solutions..

Green on light is blinking, but no picture - Television - iFixit

https://www.ifixit.com/.../Green+on+light+is+blinking,+but+no+pict..
iFixitOct 3, 2014 - The Sharp LCD TV LC37SB24U set worked until off button on remote ...The green light is blinking any time power cord is plugged into the wall outlet. ... It does sound like either a bad inverter board or a bad power supply. .... On the clad sidethere is no connections or ribbons that indicate hard current draw ...

Try pressing and holding the button for a second or two. You may also try using a remote control to power on the tv

I’m happy to assist further over the phone at https://www.6ya.com/expert/robert_aad3edb7dfa380b9

The real issue is do you have sound or not?

You can unplug the set and or a box both if connected for several minutes and then power back to see if when they reboot set works or not.

You were hit also sounds like.

Sounds very much like a screen fault to me - the set powers up and senses the fault so shuts down again- seen this fault a fair bit I'm afraid.

your main board has gone bad. Can be fixed, in my shop it would cost about $250. It is a real shame on the industry that these things last about 2 years or less. Hope you held on to your old crt style tv.

Unplug your television for fifteen minutes or so then plug it back and that should bring back the video.

call a tech let them check your tv if no power it will be the power supply or related circuits.if you have sound then it could be video circuit module.as you said that it dont have pictures you did not mention anything about sound.good luck