WE are getting MO disk not ready error while we are testing with HP Surestore optical 9100mx. what we have to do? pl reply

http://btjxfvm.enjin.com/mobile/forum/viewthread/m/29507069/id/19191576-9100mx-manual

You simply visit
HP Customer Support Dial 1 855 622 0254 To Take Care of HP Products and take any help free of cost. Hope this helps you out.

Check the HP web site for this problem? Seem it is not reading a proper disk?

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

The error message means that the MO disk hasn't come up to speed. Try a different disk.... That's pretty old technology, it may simply be worn out.

See the manufacturer's web-site:

http://vdccnzitg.houston.hp.com/GPL/search.aspx?language_code=en&country_code=US&SearchType=HHO

and enter your location (within 10 miles), and search for the nearest SERVICE CENTER.

Do you have the Restoration Disk?

You have corrupted basic Windows files. How? Windows is a funny animal. That, and viruses just drive Windows users crazy.

The Restoration (CD) Disk has the basic Windows files. You can do a Repair.
Start the computer, insert the Restoration Disk in the optical drive. Close the drive tray.
When asked perform a Non-Destructive Installation.

Don't have the Restoration Disk?

Contact HP Support.
The disk/s are free. The shipping and handling is not.
In the US the phone number is 1-800-474-6836

It's $17 for a 5 to 7 day ship, $24 for a 2 to 3 day ship.

Not in the US?
Here is the HP Support Worldwide contact page,

http://welcome.hp.com/country/us/en/wwcontact_us.html

Your drive is not spinning up because of ither a read channel calibration error- or a focus servo error- assumimng your using the same media you always have been- and its not REALLY dusty.

Read Cal failure is caused by the controller and the Focus Servo Failure is caused by the optcs module-

repair cost $285 for either.

At Optical Storage Repair

[email protected] cheapest , fastest and best.

ptical Storage Repair

you can get the infomation about cost here:-
http://www.ciao.co.uk/Sony_EDM_230CDF_1_x_230_MB__5615745

and for drivers visit sony web site under support section.

I don't think the drive can be adjusted or calibrated. It's dependent on the operating system and the drivers it uses.

It could be the drive itself needs to be replaced so that it can read the format you need.

Is there a way you clean the thing?