Question about Watches
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: opening an elgin pocket watch
The best tool to do it is watchmakers knife, but any proper knife with hardened steel blade can do the job. Make sure the blade is NOT flexible.
Check carefully the sides of your watch and you will notice the groove. Place knife blade into that groove and press it in. At the same time try to make a scooping turn to lift the caseback. Usually there must be underlayed caseback as well and it opens exactly in the same manner.
Make sure you do all this carefully and do not let the blade to slip or your watch will end up with nasty scratches or even damaged movement.
That job isn't a big deal, but requires some skill, so, BE CAREFULL.
Don't forget to rate, please.
Posted on Jan 05, 2009
First you must say what type as there are differences depending on the mfg and model.Be the following basics apply.
1- Put the stem in the setting position (usually pulled out if stem set).
2 Them open cover to expose the movement. ( Screw off or snap open).
3- Remove the movement (Usually held in place with 2 screws at the outer edge.
4-Then if there is a screw in the part that holds the stem loosen that.
5- The stem can be held with a pair of pliers on the flat and the crown unscrewed. Be careful not to damage the square (FLATS), with the pliers. A rag or other safety measure should be taken.
6- then inside the stem hole, looking from the ouside the is an annular area around the stem that has a ferrule screwed into the case this has to be unscrewed and will bring out the stem and the ferrule.
This siounds complicated but the steps are more involved to write than they are to perform.
There are many variations to this process, and each type should be understood before proceeding.
Posted on Nov 24, 2009
The back screws off counter clock wise.
If you will post the ser number off the movement we can tell you almost all production information about this watch.
Hope this tip helps.
Posted on Feb 17, 2010
Tips for a great answer:
Nov 08, 2016 | Elgin Watches
Apr 30, 2015 | Elgin Watches
Feb 14, 2015 | Elgin Watches
Aug 22, 2010 | Elgin AU13 Antique Pocket Watch
Mar 29, 2010 | Elgin AU13 Antique Pocket Watch
Mar 08, 2010 | Elgin Circa 1904 Watch
Feb 16, 2010 | Elgin Circa 1900 Watch
Dec 25, 2009 | Elgin Circa 1900 Watch
Oct 21, 2019 | Watches
32 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: