When I try to weigh something on my Salter kitchen scale, after the 88888 shows, then an "E" comes up, so that I can't weigh anything. What should I do?

SOURCE: Can't open battery case

The middle part slides out. You'll need a small knife or a screwdriver to pry it out gently.

There are openings on two sides. One side has a larger opening than the other. Make sure you pry it out of the lager opening.

Once you gently slide it out, you'll see the two batteries. Make sure the positive side is facing up when you put them back in.

Hope that helps!

SOURCE: my salter 1004SSDR kitchen scale won't show any

Your salter scale has a 15 year warranty. I would call the customer service number 1-866-843-3905 and ask them why it won't zero to weigh anything. They may replace your product.

SOURCE: Reset digital bathroom scales

I cannot reset my digital scale to lbs. it is a conair ww body mass scale

SOURCE: setting the clock on salter scale model 5007

Hold down the g-oz key and the off key at the same time for about 5 sec's
The hour digit will flash
press the ml-floz key to move the hours.
then press the g-oz key again to move to the minutes.
press the ml-floz key again to set the minutes.
press the g-oz key and it moves to setting the cloak to 12h or 24h option.press the g-oz key to set the time.
And your done.

SOURCE: I changed the battery on bathroom scale Salter 987

I had the same problem with my Salter 987 scale. Pull the battery out for about 10 seconds and put it back in. Then push the scale once so it turns on. After the blinking stops, push it once more. The scale will now zero itself. After the scale has zero'd itself it may turn off after a brief moment. It's now ready to use normally. If you're standing on the scale when it's trying to calibrate to zero, it will assume your weight is zero. Don't stand on the scale after replacing the battery untill you first complete the steps listed above.