I have a Jenn Air french door refrigerator Model # JFFCC72EFP02 Is this vertical seal hinge temperature suppose to be cold? I am experiencing condensation on it .

What do you mean by "pops"? If your problem is the door, then it is possibly leaking out your cold air. It could be the seal or the hinge.

Larger=colder. Make sure that 1) your magnetic strip around the fridge door is sealing well. Even a small leaking area could make it difficult to keep cold, especially in warmer areas. Also, make sure there is nothing obstructing the door from closing completely and sealing properly. I had this same issue where one of the door shelves was unlatched a little and the door would close but not seal. Beyond that could be motor or more likely compressor or coolant leak. Good luck.

The refrigerator portion is fed cold air from freezer section to cool it. Check for the freezer fan and/or the damper mechanism that directs air into fridge compartment for proper operation.

check the gasket on the door or the hinges

When the refrigerator is not cooling but the freezer compartment is cold, this is usually the result of a defrost problem.
http://refrigeratorheaterrepair.blogspot.com/

The water could have been frozen in the door and melted when your fridge warmed up.


The lower hinge on each door may have a door closing cam. It raises the door up ¼ inch when opening and this assist in closing the door. If it’s wore out and doesn’t work the door may not seal and the gasket can be damaged. Watch the operation of the door to see if it rises up when opened.



The fridge gets its cold air from the freezer through a vent(damper) between the freezer and fridge.The fan in the freezer blows air through it. There is a flap you adjust with the fridge temp. control. Make sure it's opening and closing when you adjust the fridge temp ..

If the evaporator coils behind the back panel of the freezer are icing up because of auto defrost failure that will stop the circulation of cold air and eventually affect the freezer too.

check defrost timer, defrost heater, defrost thermostat. In most newer models the timer has been replaced by an electronic control board. If the heater and thermostat are ok it’ll be the control.

How to check stuff>
http://www.acmehowto.com/howto/appliance/refrigerator/refrigerator.php

have you tried to re align the hinges? is the hinges broke?

Try partsdirect.com they have one of the best parts resources available. you will need your complete model number off of the inside of the unit it is located either on the eiling or right hand wall of the refrig section. thx Peyton

there is a heater runs through there that keeps the seals dry so they dont mold from condensation from opening the doors its called a mullon heater

You can use cooking oil or wd-40 to go around the rubber seal of the door especially near the hinge to make sure it has a tight closure