Maytag Neptune front loading washing machine, in last 5 minutes of cycle, would make a lot of noise and just now, while doing a small load of towels, the washer had stopped, before it was finished, with an FP code and there was water in the tub. It will not restart. What should I do?

Pour 2/3 cup of liquid chlorine bleach into the bleach compartment of the dispenser drawer of your Maytag Neptune front-loading washer.

Run your Maytag Neptune front-loading washer on the "Clean Washer" setting. Press "Start" to start the cycle.

Leave the door open once the cycle is complete to allow the inside of your Maytag Neptune front-loading washer to ventilate and air dry.

Look closely at the gray seal of the Maytag Neptune front-loading washer's door opening. This seal can have a buildup of debris or detergent residue.

Spray the seal with an all-purpose appliance cleaner and scrub away any debris or residue with a cloth or scrubbing pad. Dry with a clean cloth.

Remove the soap dispenser drawer. Press the release lever and lift it out to clean.

Take out the inserts and rinse them and the drawer thoroughly.

Wash with a mild soap and cloth to remove any residue. Dry thoroughly before replacing.