How do i get fault codes for maytag gemini? - Maytag MER6772 Gemini Electric Kitchen Range

Hi klevebv1,

The F9 fault code description is a Door latch supervisory (door latched). Unlock door and check switches or clock assembly (also called the ERC).

Hope it helps.

Thank you for using FixYa.

(Positive feedback will be greatly appreciated.)

Check and or replace the other sensor.

Maytag / MAYCOR / Magic Chef / Jennair / Admiral
Oven Fault Codes
Display Condition Remedy
F0 Function key shorted or stuck button Clean and unstick button or replace Touch Pad or Clock
F1 Defective Touch Pad or Membrane Replace Touch Pad or Membrane
F2 Oven over heat defective Relay Board or (if present) or defective Sensor
F3 Oven Sensor Open Replace Sensor
F4 Shorted wire or Sensor locate short and correct it or replace Sensor
F5 Hardware, safety circuits disagree Replace Clock
F6 Missing AC (power) signal Check for proper voltage (plug, breaker, etc.)
F7 Function key shorted or stuck button Clean and unstick button or replace Touch Pad or Clock
F8 A/D Warning Replace Clock
F9 Door Lock Warning Check door lock circuit or Replace Clock

If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

This is a bad touch pad on this unit. You normally have to replace the touch pads when you replace the sensors.

Contact us at:

http://www.fixya.com/repair/d499389-accurate_appliance_repair_service
for all your appliance questions and parts for all your appliances.
Happy New Year to you! Ella

Here is a link with a list of Gemini fault codes and what the problem is , Hope this helps! http://www.repairclinic.com/0078.asp#Maytag

F-1 error is a Temperature Runaway. It Maytag's way of letting you know that oven overheated. Nothing you have done but it may have shorted out the oven sensor or the keypad. Check the sensor and see if it's closed. If it's okay, replace the keypad.

www.servicematters.com has fault codes for all maytag, tech sheets for most anything.....for free

I haven't checked anything but the heating element. The fault codes read F0-0, which means no fault but..... ?

This code is in responce to a fault/failure in the lower keypad assembly. It is possible the keypad was bumped.

Maytag Gemini fault codes.
Fault code Suspect area Fault code Suspect area
F0 - 0 None
F1 - 1 Runaway cook upper oven
F1 - 2 Runaway cook lower oven
F1 - 3 Runaway clean upper oven
F1 - 4 Runaway clean lower oven
F1 - 5 Keypad cancel upper
F1 - 6 Keypad cancel lower
F1 - 7 Keypad disconnected
F1 - 8 Keypad shorted
F1 - 9 Slave

I had same problem, error code F 1-8, shorted keypad. I was so frustrated I went ahead and tore it apart. There was a surprising amount of gunk and moisture between the plastic face and the actual contacts. I cleaned it up and let it dry out. It worked OK for a while, but the seal is not good, and moisture from baking is still getting into it. When it goes bad again, I'm going to take off the plastic face and just press the sensors with a pencil eraser. I'll probably replace the range within the year. No way I'm paying $385 for new pad + installation on 10 year old stove.