Making a loud noise when on the spin cycle and not balanced

drain or drain pipes blocked
bearings gone

This could be the drum baring and probably will need professional engineer to do it.

1) most Noises coming from washing machines coming during the cycles of SPIN .Clothes load can be un-balance. Stop the machine and balance the clothes.Start again, and repeat the step if necessary.

God bless you

Check to make sure that your clothes are not piled to one side causing the load to be off-balance. If that does'nt fix it then, It may be that your machine has a balance stabilizer on it that has worked its way loose or even off.

Perhaps the balance weight has come off?

check to see if the washer is balanced (cloths are evenly placed in drum) if it sounds like banging noise

If it makes this noise in the agitate mode and not during the spin cycle, I would suspect that the transmission is going.

Washer may be out of balance, Move closes around in washer and restart

Remove the front panel and you will see two metal guides attached to the front of the frame. One of them will probably be bent and the transmission assembly will have jumped over one or the other of the guides. You need to manually pull it back to center then straighten the bent guide. May have been caused by load being out of balance or machine not properly leveled. Good luck.

I replaced the drive block and it solved my problem. (thumping noise at the end of spin cycle) Easy repair. Videos on utube show all the steps.