Scooter will not move

Hi I found this fault code .cheers

Amigo Scooter Oxygen Tank Holder Light flash key turned ...

www.fixya.com > ... > Amigo > Amigo Scooter Oxygen Tank Holder
... key on my phoenix 3 scooter the red light flashes 5 times and the scooter will ...scooter wont move,although on the little speedo there is a red light flashing on ... ...light is flashing when the key is turned on. the scooter does not move at all ... flash up and down the console light and you at this point have to turn the key off ...

My pharmore wizard diagnostic light flashes 9 times and my ...

www.fixya.com/.../t25197681-pharmore_wizard_diagnostic_light_flashe...

Oct 8, 2014 - my pharmore wizard diagnostic light flashes 9 times and my scooterdoes not go, can someone help me please - Mobility Scooters question. ... Have no manual for pharmore 4 wheeled wizzard light on but wont move ... Why did it stop working suddenly and is blinking console light in 5-blink sequence?

The amount of times the light(s) blink is a flash code that indicates what the problem is. Count the number of times it flashes then pauses. We can answer your question when we know what flash code you are having.

Hello,

Look at the joystick when the chair stops. The battery level lights should be blinking a certain number of them repeatedly. The lights are a diagnostic code. The number of the battery level lights blinking will tell you if you have a motor, joystick, module or battery problem.

look in the back of your manual for troubleshooting, are you getting any blinking lights or beeps

Has the scooter been sitting unused for a while? Will the horn honk when the scooter is connected to the charger?
If the batteries are charged and NO LIGHTS come on at all when you turn the scooter on, please check all of your connections, most importantly the fuses as your circuit may be incomplete.
If there was any power getting to the scooter at all, the lights would at least blink to let you know there was a problem.
When batteries sit for a while they will oxidize and go solid which may prevent them from getting a full charge. The charger shows them as full but it is just the current bouncing back from the solid core. Try replacing the batteries to see if that solves the problem, if not, contact the manufacturer.
Good luck!

Check this website to find the type of controller your scooter has. The number of blinking lights will give you an idea as to the the problem is. You may need to reset the system after replacing the batteries. Check your manual for troubleshooting diagnostic codes.
http://www.pgdt.com/scenter/diagnostics/diagvsi.html
Good luck!

Remove the seat and the plastic cover over the batteries. look at the lights in the cover or at the back of the scooter an see if they are plugged in. It is a common fault of when working on the scooter to forget to plug the lights back in on assembly. Hope thats what it is.

Check the brake at the back of the scooter

may be the battery has been damaged. you will have to replace the battery.