What does yarn round needle lol like - Sewing Machines

Hi, Just wrap the yarn right round the needle then knot your purl stitch it should work fine. :-)

That depends on the yarn being used. Basically, you need the needle size and yarn that produces the gauge in the instructions, ie you knit a swatch and measure it against the gauge and then adjust the needles until you get the gauge specified.

k2tog yrn, means Knit two stiches together and put the Yarn Round Needle to create a new stich

Perhaps this will help (yarn round needle):

How to Knit the Yarn Round Needle Increase YRN


...

yon is usually Yarn On (or over) Needle. This is a yarn over between a purl and a knit stitch. (After the purl stitch, keep the working yarn in front of the needle. Then place the right needle into the next stitch so that the right needle is behind the left needle in the stitch. Wind the yarn around the needle and pull the loop through.)

yfrn is a Yarn foward and round the needle. This is a similar yarn over to the yon but is a little larger. The difference is that the yarn over is done after a knit stitch and before a purl stitch. After the knit stitch, bring the yarn in front of the needle. Wrap the yarn anti-clockwise around the right needle so that the yarn is again at the front of the work. Place the right needle in the front of the next stitch on the left needle. Then do a normal purl stitch.

You can see some videos and still photos here: http://www.stitcharena.com/library/hand-knitting/yfwd-yfrn-yrn-and-yon/ .

I hope this helps.

Cindy Wells

It means pull the thread in front of the needle

Replace the needle it might be bend and check if it is the right needle for the work you are doing. You get for example stretch needles, denim needles, needle for thick/thin yarn, thick material ect. Using the wrong needle for the wrong material can cause skipped stiches especially if it did not do it before. Clean and oil the bobbin holder and make sure the bobbin is threaded correctly. Can also adjust top yarn tension as a last option.

Get your local technician to adjust needle/hook timing.

a quilting bar attaches to one of the feet usually in the back and is attached by a little set screw. it is used as a guide to ride a long a previous line of stitching or a design to keep lines of stitches the same distance apart.
I'm familiar with 2 different types of cording feet. one looks like a zipper foot... very narrow and a notch on the side of the foot instead in the middle. to make cording ...fold a narrow piece of fabric in half and place yarn or cord along the inside of the fold.next place folded fabric with yarn inside under presser foot. but up the foot next to the yarn bump on the top side of folded fabric and stitch as close as possible. the second kind has a groove on the underside of the foot and the yarn bump follows this groove stitching is also done close to the yarn. some concideration in needle placement is needed depending on the thickness of the yarn or cord. always hand turn the needle up down the first few stitches to make sure the needle does not hit the foot.adjust if needed.