How to connect power led ,HDD,Reset,power SW cables in ESYS 865gv/775 Mother board. Thank you

http://www.cintelcorp.net/msi-ms7528-manual

You should read the motherboard manual, for cabling:
1. Power SW
2. Reset SW
3. HDD led
4. Power led - and power led +
5. Speaker
Cabling scheme, also written on the motherboard.

If the Power SW not installed the switch on does not work.
If the Reset SW not installed the switch reset does not work
If the HDD led not installed the hard drive light (red) is not lit
If the Power led (+/-) not installed the power light (yellow) is not lit
If the Speakers are not installed, when the computer is on the beep sound is not heard.

I hope this information helps.

You can download a manual from this WEB site.
http://freemanualonline.blogspot.com/2011/04/gigabyte-ga-8i865gme-775-rh-manual-user.html

Here is a few pictures that shows you how to connect your cables:



I am not sure which one it is, but these are the most common ones.

Hope this was helpfull.

install sound card

u will find front pannel connection pins on mother board. its in 2 lines. in onle row there is one pin slot idle. next to that vacant pin slot u insert reset sw, next to it insert hdd led, behind hdd led insert power led, next to power led (behind reset sw) insert power sw. thats it done

if you need a mother board installer dont worry email @ [email protected] give back your email and ill send you youre need drivers or what kind drivers you need..thanks

on most motherboard it is possible to read there to set the wires.
hope this helped a little.

Go to the site below. Its a manual for the 800/i65GV group. Go to page 67 and zoom in. You'll get a nice look where everything goes. Two rows of pins. Upper row and bottom row. Real close to each other. Do not place connectors up to down. Connect only left to right.
The reset connector has two pins. One will be white or black. These are - grounds. So connect it to the bottom row onto the most right two pins. Moving to your left. Skip one pin. Take the Power Switch a two pin connector. Remember Black & White is ground & ground goes to your right for both rows of Mb pins.
http://dlsvr03.asus.com/pub/ASUS/mb/sock478/p4p800/e1324_p4p800.pdf
Go to IDE_LED next. Its the last two pins towards your most left of the bottom row of pins. Move to the upper row & the power LED. Same as the bottom row keping the grounds to your right. Lastly is the speaker. Its connector holds four pins but you only use two. One in each end.

Good luck & please vote....