SOURCE: philips universal remote code for direct tv.
I have a code table for you, you may try this if its different than yours. Here is the direct link (You need Adobe Reader to open it)
Good Luck
SOURCE: toshiba tv code for Zenith remote
Check the manual for your Zenith; many of the Zeniths (and many others) have a 'scan' mode you can call up, in which you can repeatedly press one key (^ for example), then the Power Button. That will force the remote to set every code it has available, step by step.
If you no longer have the manual, you may find it here or several other sites that offer these.
SOURCE: philips universal remote codes for symphonics tv
Manually turn on the device you want to control
1. press and hold the CODE SEARCH button til the light stays on release the code search button
2. Press and quickly release the desired button ( TV, DVD, etc ) the red light blinks off once
3. Press the CHANNEL UP button repeatedly ( up to 300 times ) til the device changes channel and stop
(the red light will blink off after each time the channel up button is pressed )
4 Press the MUTE button to set the code
hope this helps
SOURCE: tv codes for a rca universal remote controller
need remote control codes for a toshiba 32A35 with a rca remote
RCA
HI,
Direct
Code Entry:
Find the code your
device.
1. Press and hold "CODE SEARCH".
2. Press and release the TV, VCR or Cable button. If programming an AUX
position, press and release AUX first and then press the device type to be
programmed.
3. Enter the 3-digit code number.
4. Release "CODE SEARCH".
5.
With the device on, press another button to test (volume control/power
button).If it does not work, repeat steps 1 to 5 with other codes which you
have.
follow the below steps
to set remote without codes
Code
Search:
1.
Turn on the device you wish to control.
2. Press and hold "CODE SEARCH".
3. Press and release the TV, VCR or Cable button. If programming an AUX
position, press and release AUX first and then press the device type to be
programmed.
4. Release "CODE SEARCH".
5. Press ON/OFF repeatedly until the device turns off.
6. When the device shuts off press and release ENTER.
7.
Try using the remote. If it does not function repeat steps 1 through 6
To Get The Code Please Go To Below
Website:
http://www.rcaaccessories.com/remotefinder/
You need to select the following
information from the drop down list
1.Model of the remote
2.Type of device to which you
want to program(TV/DVD/VCR)
Thank you
95 views
Usually answered in minutes!
×