Panasonic viera my red tint is gone from my tv. only an orange tint. any advice? i need help.thanks,bigeazyatzeg

If there is no yellow socket (terminal) on the TV, as in most recent year's VIERAs:

Connect the Yellow male plug from your gaming device into the TV's GREEN female socket (terminal).

Press INPUT on the Panasonic TV remote and select the Video input. In some VIERA models, you need to press INPUT, go down and select the Comp. option and then press >right to select Video.

To get audio (sound), make sure to connect the Red and White plugs from the gaming device into the TV's Red and White sockets (terminals) that are labeled AUDIO.

Purple Panasonic PC>TV Problem:
The VGA cable uses three primary color RGB channels.
Red, Green, and Blue.
The picture is made up of pixels or dots arranged in a grid along the "X" horizontal axis and "Y" vertical axis.
The computer mixes the intensity of each color channel to create a unique color per pixel.
All RGB at 100% creates white.
R+G creates yellow.
R+B creates magenta, ie purplish.
G+B creates cyan.
So a purplish tint sounds as if your Green wire has no signal, which may indicate a faulty VGA cable or VGA socket.
Put another way, (R+G+B)-G=R+B=magenta.
So try another VGA cable, spray all socket pins with "Servisol " or similar contact cleaner.
0%<--------->100%
Cyan<------->Red
Magenta<--->Green
Yellow<------>Blue
All 0%=Black; All 50%=Grey; All 100%=White.

set is trying to move from standby to power supply on and not making it, No model indicated so best advice is take to some shop and get an estimate.

Check the blue and green plugs on the component cable. Make sure the are pushed in all the way on the back of tv and device (cable box, dvd player, etc.)

Hi,

The Settings are :-

-Picture menu Picture mode: Custom
Picture: +80
Brightness: +60
Color: +44
Tint: -8
Sharpness: 0
Color temp: Warm
Color management: On
x.v.Color: Off
Zoom adjust: [grayed out]
-Advanced picture submenu
Video NR: On
3D Y/C filter: [grayed out]
Color matrix: [grayed out]
MPEG NR: [grayed out]
Black level: Light


Let me know, if needed further assistance.


Hope i helped you.


Thanks for using ' Fixya ' and have a nice day!!

Ours is doing the exact same thing! I came here hoping to find an answer. Did you figure your tv out?

Hello

black strip down the right side its about 2 inches wide there are also red and green flashing lights that is defective shorted capacitor at power inverter board section that was 300uf 200volts.

Angel
Thanks...

Your red component cable needs replaced or your red component input in either your DVD player or TV needs replaced.

If you have the halo 3 bonus disk use the THX optimiser on it, if not then the setting I use are:

Viewing Mode: Dynamic
Contrast: 60
Brightness: 50
Colour: 50
Sharpness: 50
Tint: Middle (need the lenses to set it properly)
Colour balance: Cool
Colour Management: On
P-NR: Off

I got both setup through HDMI atm.

A red light blinking 10 times means that a video board has gone bad. Contact Panasonic to see if they will help you out.