Question about Briggs Measuring Tools & Sensors

Open Question

Ariens zoom 42 mower keeps flooding with gas, why or what is the possible cause to this? We have removed the carbuetor and cleaned it out (even though it was not dirty) and replaced the spark plug.

Arienz Zoom 42 and has a briggs and Stratton intek ohv engine. Just runs for a minute and kills....it is getting too much fuel.

Posted by Anonymous on

Ad

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 583 Answers

SOURCE: Briggs & Stratton Briggs Stratton Intek V -

these are common for doing this ,if you dont want to pull it down and hone the cyl. then i would use a heavier oil say 20w/50and that will probabley solve your problem

Posted on Oct 25, 2009

Ad
  • 10 Answers

SOURCE: we have 42'' Yard Man riding lawn mower need to how to change oil

it's a square head pipe plug @ base of eng. either right or left side of machine may also have a quik change fitting instead its black plastic w/ yellow cap

Posted on Apr 12, 2010

Testimonial: "Thanks for the info, you where right on the money.. I finally found it, its on the right side if you were sitting on mower. Thanks again!"

  • 885 Answers

SOURCE: what would make gas flow out of the spark plug hole on a briggs and stratton 18hp ohv intek?

If you are getting that much gas out of the cylinder you most likely have a stuck fuel float valve or the float itself is damaged in the carburator. Make sure you check your crankcase for gas also, usually when a float valve sticks it also fills up the crankcase with gas. Hopefully you just have some debris caught between the needle valve and seat that can be blown out. If not replacing the needle valve and seat or float is relatively inexpensive.

Posted on Mar 02, 2012

  • 6468 Answers

SOURCE: Ariens 1640 Zoom Riding Mower with Briggs & Stratton engine smoking

check to see if the oil smells like gas the needle valves go bad in the carb and gas over flows into the crank case also the head gaskets go bad and **** the oil from the crank case

Posted on May 10, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

No fuel flow to Briggs & Stratton Intek, 18.5 hp


blow air back threw the line towards the tank you have something clogging it or you forgot to turn the fuel on

Jul 07, 2012 | Briggs & Stratton Briggs Stratton Intek V...

1 Answer

24 hp briggs intek starving for fuel


Always check for jet. 90 percent of the time it is clogged. Remove the bowl and float and it is the center screw.

Jun 10, 2012 | Briggs & Stratton Briggs Stratton Intek V...

1 Answer

16hp B&S ohv runs for 30min under load then stops 5min cool off starts runs 30 min new coil plug gas is venting adj valves


could be fuel vaporising.... re rout the fuel line away from heat sources this may help or the fuel is not getting to the carby fast enough....check fuel filter and lines for cleanness .

Jul 22, 2010 | Briggs & Stratton Briggs Stratton Intek V...

1 Answer

Brigss and Stratton engine getting to much fuel


I HAVE A BRIGGS & STRATTON INTEK 18.0 ,JUST FINISHED CUTTING THE YARD,WENT BACK ABOUT 20 MINS LATER TO PUT LAWN TRACTOR AWAY. WILL NOT TURN OVER WHEN I TRY TO START, FUEL LEAKS OUT OF THE EXHAUST AND AROUND THE BOWL

Jun 19, 2010 | Briggs & Stratton Briggs Stratton Intek V...

1 Answer

B&S Intek OHV 18hp muffler glows red hot


sounds like its running too rich on fuel. try turning the fuel mixture screw in 1/4 turn at a time til it starts to stall then turn out 1/4 turn or 2 and see if that helps.Maybe when you used the air it turned this screw???

Nov 10, 2009 | Briggs & Stratton Briggs Stratton Intek V...

Not finding what you are looking for?
Measuring Tools & Sensors Logo

Related Topics:

22 people viewed this question

Ask a Question

Usually answered in minutes!

Top Briggs Measuring Tools & Sensors Experts

ShedThoughts

Level 2 Expert

199 Answers

 steve
steve

Level 3 Expert

25437 Answers

Tom Chichester

Level 3 Expert

52781 Answers

Are you a Briggs Measuring Tool and Sensor Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...