Moen kitchen faucet. I changed the cartridge but

There are flow checks in either the hot and cold supply lines, or there is one on the hose. It sounds like it is failing. If it's an older model, then the flo checks will be located right at the end of the two copper tubes coming out of the faucet, and can be removed using needle nose pliers. If it's a newer model, then the check is in the hose and the hose will need to be replaced.

Hot water side of most faucets give most problems try heating with hairdryer pryor to trying to remove,contact moen tell them of your situation they will more than likely send you a new cartridge free of charge if you raise enough stink about just replacing cartridge.

take the handle off the hot water side. unscrew the cartridge and check for sediment.

remove the device from faucet and look into it for a small screen is it clean.

if memory serve's me,you will need to remove a stem extension,screw in center,and you may need a tool #103462 to remove cartridge.1'st stem ex't is red,(hot) blue (cold), remove, look down,white piece w/ 2 notch'es, this hold's cartridge down, ya might try needle nose plier's to remove,a little lube help's upon re assembly, carefull w/plastic thread's

pretty sure that model has shut-off's/stop's.they are on either side of the center of faucet,they take a slotted screw-driver.check that,and the balancing spool could be clogged,if the stop's are open check the cartridge real good,as well as the faucet body for any debris. if you end up pulling the cartridge flush out the valve body to prove flow from both hot,and cold.

Hot water line connected to left side of faucet? Did you replace tap set, or just cartridge? Cartridge may be out 180 degrees.

I have moen kitchen faucet # 7560 and water pressure very low. What should I do? We check water flow in pipe it is ok. I changed cartridge as well as pipe nothing help. Please let me know. thanks

Try replacing the cartridge first.That's your best bit . Next would be the whole valve. Hopefully, it's just the cartridge.

http://www.moen.com/browsecatalog/catalog/specpartsearch.cfm?location=TopNavCustomerSupport

Moen uses a cartridge on their faucets. You have to remove the handle. You will find the stem and a small U shaped retainer. Pull the retainer out and pull the cargridge straight up. Sometimes the cartridge is in there pretty tight and you have to pull hard. Once you do this, take the cartridge to your local hardware store. Replace it with the one you have because they have 2 different one. Install it back in the same order it was removed. Hope this helps and good luck.