Help with red flash?????

click start control panel administrative tools computer management device manager scroll down universal serial bus controllers you could see a yellow question / exclamation mark? ! or a red X

you will need to update/reinstall drivers

right click to reinstall drivers

if you can see your usb drive but its not working

ports (com&lpt) right click update driver if this fails to fix the problem

check the USB leads that attach to the motherboard usually red white green black make sure they are securely seated and have no

dust build up on them dust will cause static and a lot of unforeseen problems to a computer and its parts

if you need more help with post a reply

hope it helps

Remove the back and check for bulged electrolytic caps on the power supply board, or replace the power supply.

The camera is in Red-eye Reduction mode. The preflashes are intended to get the subject's pupils to contract, reducing the red-eye look.

Press MENU to display the menu. Press right-arrow to select the toolbox icon (Setup). Press the arrow keys to select Red Eye Reduction, and turn it off.

Do you mean your subject's eyes are showing "redeye"? This is a common problem with cameras that have the flash very close to the lens. Almost every photo editing program has a tool to remove red-eye. Check your computer to see what you have installed. In the future, most cameras have a red-eye flash setting which shoots a short flash before the main flash to close down the pupils in your subjects eyes to eliminate red-eye. You could also turn up the lights in the room...sometimes that helps.

Check in your TV's settings for a selection called "Game mode" It will turn off the scaling chip in the TV(The PS3 will scale the image anyway) and remove the lag it was producing.

A 1995 60 inch rca good picture and sound. Then it started a cracking noise and a hissing sound, then the picture went blurry. then it was nice picture and sound, then it died. took the back off and turned out the lights. Plugged the tv in and out from the wall socket and there was a sparking noise and a small arc when i plugged it in and out a few times ,at the part that the power plug plugs into.The white part that is beside the white power plug part has thick red wire coming out of it and goes into another plug that has more red wires in it. but the big white part beside the power plug part looks burnt and has black powder on it. that part is probably the problem but maybe not, what it the name of that part and how much would it cost and is it plugged in or soldered.

Turn off red eye reduction and you'll only get one flash.

the firmware need to be reflash on the phone so take the phone toa mobile service center and have them flash it for you or you can do this online at topsony.com.

you are possibly using it too close to subject. Make a softening/dimming filter with layer of tissue paper over the flash- the more tissue the less light gets out

I've seen some of those white eyes photos. Some are down right scary. I'm sure you have encountered red-eye when taking flash photos of people. With some animals, it is not red - but white. .... Try to catch the animal looking away from the camera when you take that flash picture. Have someone distract him/her. ............ Fixing Demonic Pet Eyes http://graphicssoft.about.com/gi/dynamic/offsite.htm?zi=1/XJ&sdn=graphicssoft&zu=http%3A%2F%2Fwww.myjanee.com%2Ftuts%2Fpeteyes%2Fpeteyes.htm http://graphicssoft.about.com/gi/dynamic/offsite.htm?zi=1/XJ&sdn=graphicssoft&zu=http%3A%2F%2Ftlbtlb.com%2Ftlbimages%2Fmax2.html