Question about Audio Players & Recorders

Open Question

How to fix amplifier of Scott MDX i90 ?

Led is turning on, I can hear relay but no VCC on fuses. More details to come:

Posted by on

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
petraman7
  • 1175 Answers

SOURCE: dead Peavey audition chorus practice amplifier.

Hi...

There's probably a 5 pin power amp IC on a heatsink inside
replace it

Posted on Apr 17, 2010

Ad
  • 6705 Answers

SOURCE: will not turn on can hear relay? click right LED flashing other solid

Did you try to switch the TV of with the on / off button or switch on the TV, not with the remote and not by unplugging the mains?
Then try again.

Posted on Feb 05, 2015

gopakumarg43
  • 76140 Answers

SOURCE: will not turn on can hear relay? clicks right LED flashing other solid

These blinks [flashes] are fault indication (Error Codes). From the number of blinks occur at one time switch ON, you can get an idea about the faulty circuit section inside it. This will make repair easy. These are called blinking codes. Make sure about the exact number of blinking of the standby/power LED, by switching On & OFF the set, for at least two times. Count it carefully. If you wish to get some details, check the site linked here. It has details about blinking codes, and fault locating procedure, to many popular brand TVs and other devices. http://electronicshelponline.blogspot.com/
Blinking codes details to many popular brand TVs are given. Surf the site with patience.
If blinks continue without any pause, the main board is faulty.


25401240-qpblz3ire1dqjhijvhvhsj0p-5-0.jpg

Posted on Feb 05, 2015

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i fix/repair 6 blinks sony bravia LCD KLV-46Z450A & shutting down problem?


These blinks [flashes] are fault indication (Error Codes). From the number of blinks occur at one time switch ON, you can get an idea about the faulty circuit section inside it. This will make repair easy. These are called blinking codes. Make sure about the exact number of blinking of the standby/power LED, by switching On & OFF the set, for at least two times. Count it carefully. If you wish to get some details, check the site linked here. It has details about blinking codes, and fault locating procedure, to many popular brand TVs and other devices. http://electronicshelponline.blogspot.com/
Blinking codes details to many popular brand TVs are given. Surf the site with patience.

May 20, 2015 | Sony Televison & Video

1 Answer

AC/Heating fan control in center consol.


honda pilot and acura mdx share a lot of the same parts. The rear blower motor resister is known to go out after a while.
http://www.acuraworld.com/forums/f8/mdx-back-seat-blower-doesnt-work-71111/

Either buy the honda part 80 bucks, or you can buy a resistor and fix it yourself for about 10 bucks. Details in the link above.

Aug 28, 2014 | 2003 Acura MDX

1 Answer

Acura 2003 MDX


check your connections

Nov 16, 2012 | Vehicle Parts & Accessories

2 Answers

Where are the fuse boxes on a 2003 acura MDX


where is the relay a/c condenser fan location?off 2003 mdx acura?

Apr 19, 2012 | 2003 Acura MDX

1 Answer

My Scott LCT37SHA TV will not turn on. I am


IF THE TV NO TURN ON THE FRONT LED IN RED CHANGE ALL 470 MF& 1000MF CAP IN POWER SUPPLY, FUSE AND VARISTOR DOWN THE BOARD. IF THE FRONT LED TURN ON IN RED ONLY CHANGE THE CAPACITORS.

Apr 04, 2010 | Scott LCT37SHA TV

1 Answer

Kac 8452


The amp probably has shorted output transistors. You'll need an ohm meter to check them. If you're new to electronic repair and want to try to troubleshoot/repair the amp yourself, read the following page and then post any questions you have.

Amplifier Repair Primer

Apr 27, 2008 | Power Acoustik LT-980/2 Car Audio...

1 Answer

Orian d5000 amplifier


output module probably gone, or switching relay stuck. Refer your problem to a certified tech to avoid injury.

Oct 26, 2007 | Orion HCCA-D5000 Car Audio Amplifier

1 Answer

Flashing Power Light


Located in the power supply section of the unit. There is a pico fuse (soldered in fuse) that opens up and there is no high voltage. The second click that you hear when the set is turned on. This can be diagnosed With set unplugged, with an ohm meter with a simple continuity test. I think the pico fuse is 4 amps , I am not absolutely sure. I have seen this problem in that unit previously. There is also a convergence problem that occurs with that set. Scrivitron.

Jun 16, 2007 | Hitachi 43UWX10B 43" Rear Projection...

1 Answer

No Sound coming out of amp to subwoofer


check the fuse box and make sure there is no loose connection there. also check the wire that feeds power to that amp. good luck

May 23, 2007 | AudioBahn DUB Mag Audio DUB1002 Car Audio...

Not finding what you are looking for?
Audio Players & Recorders Logo

Related Topics:

24 people viewed this question

Ask a Question

Usually answered in minutes!

Top Audio Players & Recorders Experts

 Grubhead
Grubhead

Level 3 Expert

5699 Answers

The Knight
The Knight

Level 3 Expert

76140 Answers

Marvin
Marvin

Level 3 Expert

85178 Answers

Are you an Audio Player and Recorder Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...