After power surge gow ro reset remote - Televison & Video

the power surge . Nothing had to do with the power surge. Maybe you must check the C.breaker or reset button from the device, TV, Dvd, OR Whatever . and try again.

Reset the code from remote control, replace the batteries, clean the batteries contacts. retight the springs contact batteries for better contact and try again. download the code www.remotecodelist.com and instruc.manual from www. fitness.manualsonline.com

God bless you

Hi,

Please visit the site HERE it.You will find a solution to your problem.

I would also suggest holding the power button on the Wii Remote itself to turn it on, or unplug your Wii Console's power cable and audio/video cable for 90 seconds. Then plug power in first, then AV cable.

Goolduck..

the power surge has noting to do with the lack of power surge.

Try to reset the c.breaker or button reset from your device TV, DVD. or amplifier and try again.

God bless you

Setting a remote mode uses battery power since the camera has to keep looking to see if it's being remotely triggered. You can control how long the camera continues to look by changing custom setting #c4. You can set it from one minute to fifteen minutes.

Try to unplug the power adapter from the printer.


Wait at least 10 seconds before replugging the adapter to the printer. This will give enough time for the printer to reset itself. Also, make sure the power cord is plugged in straight to the power outlet in the wall, bypass any power surge devices.
If the problem continues, it could be a faulty power adapter issue. Please contact Lexmark technical support for additonal assistance.

try these..
http://www-307.ibm.com/pc/support/site.w...

http://www.ja.axxs.net/unlock/
http://www.allservice.ro/forum/viewtopic...

Its really tough to break this password...

Do rate if it helped

usually that mean it had a power surge, you could have a tech look at it but could be costly. try unplugging it ro 5 mins and see what it does, if it is still blinking its prob shot.

Change the batteries on the remote, point the remote at the Sony, and hold in the power button for 5-7 seconds. Then depress and re-press the power button - see if you can get the tv remote to respond again.

Then, always try the quick reset:
How to perform a power reset on a Sony® television.

1. Turn off the television. IMPORTANT: For a projection television that uses an internal lamp, wait 5 minutes after turning off the television to allow the lamp to cool before continuing with the following steps.
   
2. Unplug the television power cord from the electrical outlet.
3. Let the television remain without power for 60 seconds.
4. Plug the power cord back into the electrical outlet. NOTE: If the television is plugged into a power strip or surge protector, remove it from the power strip or surge protector and plug it directly into the wall outlet. If the issue is resolved, the problem is with the power strip or surge protector and not the television.
   
5. Turn on the television.

Good Day, Nyung; First try ro reset TV, unplug TV from the wall for 3 - 4 minutes then plug back into wall ac outlet; 2. This model is equipped with a keyboard lock feature. To unlock the keyboard press and hold the "menu" button on the front panel for 10 seconds. I hope this was helpful, big IRISH.

Hmm...ive had this problem before and its always been either the remote wire, the rca cables or the ground. i would try hooking up the remote wire strait to the battery, if that doesnt work try to find a better place for the ground. maybe where your trunk latches. if that still doesnt work then i would try new rca cables.