Hi I'm new to this. .wanted to know how to fix openview decoder that states e52-no signal and only picks up radio stations

SOURCE: hi, the radio doesnt pick

i fixed it and ill tell you but itll cost you £19.99

RIF OFF WANKERS!

Marvin

• 85242 Answers
• Posted on Feb 06, 2009

SOURCE: radio problem toyota yaris 2000 model

this is usually caused by a defective antenna ground or a disconnected antenna lead at the back of the radio

SOURCE: unable to get a radio signal.

the antenna on the back of the unit is disconnected

SOURCE: radio

Hello george_nutti,

The model number you posted is for a center channel speaker which has no controls, and not knowing the exact model number it's difficult to be specific.

Some Kenwood KDC models allow you to select one of 3 "tuning modes", 1) AUTO1 - Automatic search for stations; 2) AUTO2 - Search Preset stations; 3) MANUAL - Normal manual tuning control. If your Kenwood is one of these models, you need to set the tuning mode to MANUAL. For Kenwood Excelon HD receivers, direct access tuning is done by using the included remote. 1) Press DIRECT button on the remote; 2) Press number buttons to enter desired channel number; 3) Press DIRECT button again to exit direct tuning.

Hope this helps.

SOURCE: DECODING A SAAB RADIO.

It will depend on the actual Make+Model

Try asking here for free advice

ukbookshelf.co.uk