How to set-up time on alarm clock radio model 1219569?Tks.

Can you comment with the model number? It will be on the information sticker on the radio itself. It will possibly start with 'CRX-'.
Try this - Press and hold the alarm set button until the display flashes like your setting the alarm time. Click the same button again and it should swap between buzzer and radio each time you click it. It will probably show some sort of logo on the display telling you which it is set to.

PDF]FM/AM Clock Radio - Sony

https://docs.sony.com/release/ICFC218_US.pdf Sony CorporationVarious types of alarms - radio and buzzer. Automatic time set - When you plug theclock in for the first time, the current time will be shown in the display.

[PDF]Jumbo Display AM/FM Clock Radio - TIMEX Audio

Snooze bar lifts up to reveal H, M, alarm and clock time buttons. To set alarm press alarm button and hold either the H or the M button. Similar for clock time.

Press and hold the "Alarm Set" button for five to seven seconds and the year will begin to blink when the clock is ready for adjustment. .

Set the year by pressing the right-arrow, "Up" or "+" button, depending on your model of clock.

Set the month, day, hour and minute. Press the "Alarm Set" or "DST" button to cycle through each field, and use the "Up," "+" or right-arrow button to adjust the values within each field.

Press the "Alarm Set" or "DST" button after setting the date and time to store the information into your clock's memory.

Press alarm 2 to change from Celsius to Fahrenheit.

Press alarm 1 to change from 24 hr time to 12 hr time.

I couldn't find the information for your particular model, but I did figure out the general procedure for Memorex alarm clocks currently in production:

1. Make sure power is turned off (no radio or whatever playing). Press the Time Set button (on some models, this is the Skip Search Back button for an iPod docked in the unit).
2. When the display blinks (on one model, the volume control knob lights up), press the Hour button (Vol. -) to set the hour, then press the Minutes button (Vol. +) to set the minutes. On the model with the light-up volume control, rotate the volume control knob to set the time.
3. When you have the time set, either wait 15 seconds or press the Time Set button again to start the clock.

Setting the alarm works the same way on single alarm models, but the Alarm Set button may be the Skip Search Forward button. Dual alarm models have separate Alarm A and Alarm B buttons.

you can read and print the manual here

http://www.skyscan.info/content/manuals/24-model-34202.html

To Set the alarm time: Press and hold the ALARM button down, and then press the hour/minute buttons to obtain desired time (Note the PM indicator on the screen for PM times)

To Enable the alarm: Move the sliding switch to AUTO or ALARM (Auto is for radio wake and Alarm is for beeping noise) *remember to turn up the volume knob if using AUTO (radio) setting.

This clock has 2 alarms to set Alarm 1, switch alarm 1 to the "set" position and make sure alarm 2 is pushed to the "off" "radio" or "cathedral" position, press and hold the "alarm" button on top while pressing the "f.fwd" or "rev" button to set the alarm....to set Alarm 2, do the opposite of the set buttons and repeat...to set the time just hold the time button down while pressing "f.fwd" or "rev"...hope that wasn't too confusing.