Question about Garden
Posted by Anonymous on
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
inlet valve connected to water inlet is stopped-up. Unscrew it, take a safety pin run through valve then take the pin and push through valve connected to pump. should do the trick. (the valve the suction hose for the soap is connect to)
Posted on Apr 08, 2009
check the non-return valves in the pump block. if these are damaged or dirty you pressure will be greatly reduced. they are located behind the 3 lage brass hexagonal caps.
I hope this helps
Posted on Sep 20, 2009
I have a Troybilt Model 2200 PSI Pressure Washer in which I have used only 2 times in the past 2 1/2 years. Went to use it this past weekend and the pump in not working. Water shoots out of the side. I bought this brand and model as I thought Troybilt was suppose to be so good. Went back to where it was purchased and had no success but to say I could buy another pump or take it in to be repaired. I believe that this power washer should be replaced at no charge. 2 uses does not constitute a few hundreds of dollars.
Have you to heard anything concerning pump problems on this particular model? Thanks for any advice. .
Posted on Jun 08, 2010
Tips for a great answer:
Oct 26, 2014 | Troy-Bilt TROY-BUILT 91215 - TROY-BUILT...
Sep 20, 2014 | Troy-Bilt TROY-BUILT 91215 - TROY-BUILT...
Aug 11, 2014 | Troy-Bilt TROY-BUILT 91215 - TROY-BUILT...
Jul 09, 2014 | Troy-Bilt TROY-BUILT 91215 - TROY-BUILT...
Sep 28, 2013 | Troy-Bilt TROY-BUILT 91215 - TROY-BUILT...
May 01, 2012 | Garden
Sep 30, 2011 | Troy-Bilt® Briggs and Stratton Chipper
22 people viewed this question
Usually answered in minutes!