How to reset code E000 - Office Equipment & Supplies

Since you listed error code E000, I assume you are talking about a Canon copier. The fuser assembly failed to heat up and the code needs to be reset in service mode. If the code cannot be reset , you need a new fuser or parts for the fuser unit. Always list the Brand and model to receive the most complete answer.

E000 : fusing problem ,check the thermistor, therm fuse and heater lamp then try to reset it by reset error code.

Your printer show Error code E000 suggests the problem history has recognized all of these of the following error codes four moments: Error code E001;Code E002;Error E003. Printer Canon E000 error will be removed in the service mode.
Please try reset factory your canon printer..but if it still show error code E000 again ,you can try with a genuine fuser unit (reseting fuser unit). Good luck

Solution 3: Try this, atempt will clear canon E000 code in Service mode:

1.Press ADDITIONAL FUNCTIONS, #
2.Go to #7 Printer and Press OK
3.Go to #4 Printer Reset and Press OK
4.Yes = ( * )

Here's your support page. If you search "e000" you'll receive the following solutions.


Solutions for e000 Issue: ERROR LCD: System Error E000

1. Reseating the Fixing Assembly-ICMF 8100 2. Resetting the machine-ICMF 8100 3. Verify/reconnect power cord to fixing assembly

Solution:
Press "Additional Functions",
Press "#", then press the "Right Arrow" button till it says, "Printer",
Then press "Set" then press the "Right Arrow" button again until it says "Printer Reset"
Then press "Set" again, the display will ask you "Yes" or "No".
Press the "Left" arrow for "Yes", then press "Set".
Now, unplug the power cord and wait 5 seconds and plug back in.

If this don't work, get a new fuser.

Issue: ERROR LCD: System Error E000
Here is what Canon says about the error code:

Solution: Reset the unit-IC D/PC 1000 Series

Reset the unit

1. Slide the platen to the left.
   
   
2. Slide the platen back to the right until it locks in place.
   

E000: Fuser did not heat up. check Fuser lamp, check thermistor, check thermostat, if this parts ok try to reset the trouble code. to reset fuser errors, first shut power off and turn on again. Then, go to service mode. Select "User mode" by pressing additional function ( * ) key then Press "ID" key ( # ) on user mode screen. Select menu 7 using cursor key. Press "OK" key. Select 4 item with cursor key. Press "OK" key. Printer reset. YES=( * ) to clear fuser error code E000.

Note: To reset E000, E001, E002, E003, go to service mode 4. select SET, go to "#7 PRINT-ER," in service mode. Then press Execute "#4 PRINTER RESET." Power the unit off/on.

Here's the definitive reset. It will work on the following models: ImageRunner 1200/1300, PC1060/1061/1080F, ImageClass D620/D660/D661/D680/D681
Press Additional Functions key
Press #
Press > to #7 Printer Function
Press Set
Press > to #4 Printer Reset
Press Set
Press <
Unplug printer and repower it.