Is black and decker building a new plant in Texas

Blade is an obsolete part. Time for a new one or sharpen the old blade.

https://www.ereplacementparts.com/black-and-decker-tr1700-hedge-trimmer-parts-c-4167_9523_9566.html

https://www.partswarehouse.com/Black-Decker-TR1700-17-Inch-Hedge-Trimmer-Type-1-s/156989.htm

https://www.searspartsdirect.com/model/4jnaoyqiey-001228/black-decker-tr1700-type-1-hedge-trimmer-parts

https://www.jackssmallengines.com/jacks-parts-lookup/part/black-decker/68004903

https://www.google.com/search?q=Black+and+Decker+Hedge+Trimmer+TR-1700+replacement+blade

Not available by part number either.

https://www.google.com/search?q=Black+and+Decker+603759-01

..

Lots of times now it's on line. Go to Black and decker enter you model # and manual. If not there go to target site.

mike

The cord is not properly wound on the center spool, or there is dirt, grass, plant parts, etc. in the spool release mechanism.
First step clean and check the spool and release.

Cheaper irons may steam better using distilled water. Minerals in water can cause this due to build up inside.

TSB 7/2006
Subject/Concern: Hesitations; Poor or no start; Deteriorated fuel economy; Diagnostic trouble codes (DTC) P1412, P0490 and P1335 stored
Model: Focus C-MAX 2003.75 (06/2003?¿½) Build Date: 14.02.2004-01.03.2006
Build Code: 4R-6S
Assembly Plant: Saarlouis
Engine: 2.0L Duratorq-TDCi (DW) Diesel
Focus 2004.75 (07/2004?¿½) Build Date: Up to 01.03.2006
Build Code: Up to 6S
Assembly Plant: Saarlouis
Assembly Plant: Valencia
Engine: 2.0L Duratorq-TDCi (DW) Diesel
Markets: All
Section: 303-08
Summary


Should a customer express concern about one of the following:


* hesitations,
* poor or no start,
* deteriorated fuel economy,
and upon investigation diagnostic trouble codes (DTC) P1412, P0490 and P1335 are stored in the powertrain control module (PCM), the probable cause is a sticky exhaust gas recirculation (EGR) valve.


To rectify this concern, a new EGR valve with a stronger EGR valve motor and revised PCM calibration should be installed.

Electric pressure washers have a switch that cuts off the power when the pressure builds up after closing the trigger. In my case that is how I got my washer. The switch stuck in the open position thereby not letting the motor start back up. I took the covers off until I found the switch which had a stem sticking out that I could push back to operating position. I was able to drill an access hole in the cover so I could push to reset my switch because I didn't have a parts list to get a new switch. When you get the covers off you can check the switch with a meter to see if it is open and possibly reset it manually for a test to see if that is the problem. The switch should be replaceable. I hope this helps.

want to register my Black and Decker blower /vac

first you get the iron hot,
then you use a damp towel,
and rub firmly

I find a lot of tools on Amazon.com, check there if your local building supply stores can't help you.

The "wedge" of the plastic lever wears, so you need to replace the lever or build up that section of the lever. Some cyanoacrylate (Super Glue / Krazy Glue) and a piece of a zip tie will work.