Question about Boating

Open Question

My wireless pedal doesn’t sync to motor guide trolling motor. It is brand new

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 5 Answers

SOURCE: i have a 37 lb thrust motor guide stealth 5forward

trolling motor parts.com

Posted on Apr 30, 2010

Ad
rockmeister
  • 2047 Answers

SOURCE: how do I reverse the

Usually this depends on the model which you have in usee. But here are 2 schematic diagrams maybe they could be of help
Diagram 1
Diagram 2

Please do feel free to request further assistance.
Hope this solution has been helpful?

Posted on Mar 13, 2011

rockmeister
  • 2047 Answers

SOURCE: i have a 1997 motor guide wireless 24volt Big

Hello there, as you said the power does not get to the bottom of the motor. The motor could be faulty or just completely bad. First you have to determine that the motor is good until you can determine this it is quite impossible to determine if there can be any fix. Take out the motor and try to power it on its own if it works fine then the problem is not from the motor but most likely the problem is from the motor. Let me know what your findings are. Hoping to hear from you soon. Thank you for visiting FixYa.

Posted on May 29, 2011

  • 53745 Answers

SOURCE: bearings for trolling motor shaft?

try a dealer who sells this machine or go on line to the maker and open up the spares section.

Posted on Jun 22, 2013

jsbenson
  • 181 Answers

SOURCE: I have a Motor Guide

How does the prop rotate? Is it hard to turn? Have you checked behind the prop for fishing line? Are you getting 24 volts to the motor?

Posted on Jan 01, 2015

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

When troll motor is switch to mom and pedal engaged motor does not run, but when switched to con it runs in this mode. this problem just started, replaced switch and problem still the same.


I'd be looking at a connection problem AFTER where the pedal connects to the unit. It doesn't take much of a "bridge" to cause an open at the chassis mount OR perhaps in the home unit itself. Since the unit runs when switched to "CON" we can eliminate a power supply issue. I'd be looking for an obvious physical problem such as a cold solder joint. Try cleaning the circuit board with silicone spray (SAFE FOR PLASTICS ONLY!!!) and see if that gives you any joy.

Hope this helps and good luck!

Oct 15, 2011 | Minn Kota Maxxum 55 Freshwater Bow Mount...

2 Answers

How do you reset remote for w75 wireless trolling motor


Its very easy:

Reprogramming the Wireless Foot Pedal or RemoteNOTE: This activation procedure applies to the foot pedal and remote.

IMPORTANT: To activate multiple foot pedals or remotes, the motor must be unplugged from the power source and then plugged

back into the power source between activating each control device.

1. Unplug the battery cables from the power source. Wait 30 seconds and then plug the motor into the power source.

2. In less than ten seconds, press and hold the "+" and "-" buttons on either the handheld remote or the foot pedal controller

simultaneously.

May 07, 2011 | MotorGuide STANDARD MOTOR REPLACEMENT...

1 Answer

Is there any way to modify in order to get more power/thrust out of a mk 30lb other than stock? or can you take a moto guide 80 lb., bow mount foot control, shaft and motor and combine it with transom...


Hey Chris,, you are starting a project (or wanting to) that is going to be problematic... It will be easier to go buy a new trolling motor with the money you are going to spend attempting this conversion... the newer trolling motors are so much more efficient...
Trolling Motors Fishing Motors Electric Boat Motors MotorGuide Trolling...
https://www.minnkotamotors.com/

Jul 15, 2017 | Minn Kota Endura 30 Freshwater Transom...

1 Answer

How do i adjust the trolling motor so when the pedal is flush or level the boat is pointing staight?


you have to pull the black gear with the 2 cables on it up off the steel slpine gear, point motor straight, level pedal and reassemble

Nov 28, 2010 | Minn Kota Maxxum 70 Freshwater Bow Mount...

1 Answer

Minn kota trolling motor will turn to the rt. when i push the pedal down to turn to the left it goes half way and stops. the pedal will not go any further


Check for rocks or debris stuck in the pedal....
If not then pull the top cover on the motor and look at the pulley cable drum. Here's a schematic:
Max 55 bowmount
Best of luck!
Mike

Jun 26, 2009 | Minn Kota Maxxum 55 Freshwater Bow Mount...

1 Answer

Trolling motor doesnt work?


Most trolling motors have in-line breakers, I would start there & see if one went bad, then check the wiring under the foot pedal for broken or corroded contacts, then you will have to trace wires & make sure everything is in order starting at the trolling motor plug.

May 24, 2009 | Boating

Not finding what you are looking for?
Boating Logo

Related Topics:

53 people viewed this question

Ask a Question

Usually answered in minutes!

Top Boating Experts

ray gallant
ray gallant

Level 3 Expert

63683 Answers

Andrew Taylor
Andrew Taylor

Level 3 Expert

28336 Answers

Tom Chichester

Level 3 Expert

52993 Answers

Are you a Boating Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...