How to adjust the armlifter of a Marantz 6150 turntable ?

The Vinyl Engine has the manual for free download. All you have to do is register with them (again, free).

http://www.vinylengine.com/library/marantz/6150.shtml

The needle skipping is caused by (A) a worn stylus. (B) not enough pressure. Which is solved by adjusting the weight on the end of the arm. It can only really be solved by trial and error. You increase the weight slightly, then play the record. You keep doing this till the record stays in the grooves but doesn't make a rumble sound. If it starts to rumble reduce the weight.

These are no more in the market and it is possible that you can get help from the support site of Marantz. So please log on to the link below and post your query;

http://us.marantz.com/us/ContactUs/Pages/ContactUs.aspx

My Marantz 6110 wasn't working right. I had it repaired at a stereo store. They told me the grease was old and had hardened which made it difficult to operate the way it was supposed to. They cleaned it and used new grease. It's been working great for the last 10 years. I hope this helps.

hi,
replace all the electrolytic capacitors in the circuit board. if its value changes this type of problem can occur.
ok

Take some off of an old receiver or other turntable. You can also buy rubber chair feet at Lowes or Home Depot in the hardware section

I have same problem - can't move platter at all - but need to replace belt

http://www.retrevo.com/support/Marantz-TT-15S1-Amps-manual/id/511dj893/t/2/

Just register and it's free.

i sent mail them  they sent me this.  they gave me adress in my country and try to mail them and ask thier shop in your country or city. pls rate this.
Hi,

Thank you for your message.
Unfortunately, this device is too old and we are not keeping archive for a so long time.
Try to contact our distributor in Turkey who will perhaps be able to help you:

ERTEKIN
ELECTRONIK TIC VE SAN A.S
GALIP DEDE CAD NO 113-115
80020 KARAKOY
ISTANBUL

Telephone: 90 212 293 93 90
Fax: 90 212 249 3512

E-Mail: [email protected]
WWW: www.ertekin.com.tr

Regards,


Philippe Hautemaison

D&M Professional
T: +33 (0) 141 38 32 50
F: +33 (0) 141 38 01 10



-----Message d'origine-----
De : EN CONTACT FORM [mailto:[email protected]]
Envoyé : jeudi 28 mai 2009 20:51
à : info
Objet : D&M Pro website Enquiry | Marantz Fully Automatic Direct Drive TT530


Name:   metehan
Address: istanbul



Town:   istanbul/turkey

E-Mail: [email protected]
Phone:  +905059674232

Subject: Marantz Fully Automatic Direct Drive TT530

Message:
i need manuel of Marantz Fully Automatic Direct Drive TT530
where i can find ? i tried your website  i didnt find. can you help me ?

This message has been generated by the contact form on dm-pro.eu | 05-28-2009 07:50:36 PM

Hi, sounds more like tje stylus tip is gone and therefore the needle isn't holding to the grooves rather than a tracking weight or anti skate problem. [email protected]