I can't open the cover to fill the tank my new T-fal ultra glide pro

fill primary thru access plate in primary cover

Fill with a 50-50 mix of vinegar & water. Heat up then try spray. Clean out all sole plate holes from white mineral deposits first. Flush with 3 tanks of distilled water after...

I have not worked on a 2014 yet but I WOULD BE AMAZED IF YOU NEEDED TO REMOVE THE FUEL TANK TO CHANGE SPARK PLUG WIRES. HERE is how to remove a 2013 Fuel Tank etc:

I believe there`s faulty construction'and the cost to repair is about as costly as a new purchase.The valve that inhibits the water flow apparently is remaining open.

Do you have duel tanks?

my 1999 ultra classic fuel filter is in the tank

On a 1992 Ultra the oil tank and drain plug are located under the right side panel in front of the right hand saddlebag.

Disconnect battery , remove the outer primary case, pull back the lock tab on the starter jackshaft, unbolt the retainer screw, then remove the two starter bolts from the right side, sometimes you need to loosen the oil tank mounts to get at these, slip the starter and coupler out as a unit, replace the coupler and jackshaft the same way they came out when the new starter goes in, install bolts , retighten the jackshaft bolt and bend over the retainer, install and fill primary case, connect battery thats it buddy

the crankcase drain plug is under the engine, but the skid plate is covering it, thats why you dont see it. oil changing is done by removing the drain plug of the oil tank

Hi,

Here is a tip that will help you to troubleshoot your iron and figure out what is wrong with it.

Electric Iron not Heating Up or not Working Right
http://www.fixya.com/support/r5300202-electric_iron_not_heating_up_or_not

heatman101