Nordictrak a 2050-controls button not working-speed is only 1 mph

English only on Fixya. We are a North American website.

https://www.google.com/search?q=Nordictrak+C2300%2C+buttons+not+working

https://translate.google.ca/

..

SORRY BUT THIS IS NOT NORDIC TRACK TECH SUPPORT

The motor controller board is faulty.
If you wish to get some details; visit the site linked here. Pull up older posts. http://electro-medical.blogspot.com/

cruise controls are controlled by the following switches and sensors
1 the switch itself
2-- the clutch pedal sensor or the VSS in the auto transmission
3 the brake sensor ---4-- the gear change switch or selector
5-- the engine speed sensor ( tacho)
6-- the road speed (VSS )
if 1 or a combination is not working or is outside parameters , the cruise control will not switch on
the road speed in a manual is set at around 20 mph and any less will not engage cruise control(CC)
changing gears in a manual will disengage CC
touching the clutch pedal will not allow engagement or will disengage CC
for some sensors run the fault codes

you req a new pcb (control board) look up your model number on google for spares .

Remove the console from the treadmill and remove the back
remove and replace the ribbon cables that run from the keypads to the control board (they are flat plastic strips that push into the board).
remove and replace all the connections on the console
reattach the console and calibrate by doing the following:
1. With the key off press the speed + and stop buttons at the same time and hold
2. place the key on and release the buttons
3. press the stop key once
4. press the speed up til it reaches 85
5. if your max speed is 10 mph then it should read about 9.8-10.2

If the keys will not work then the console is bad and would need replaced.

Remove the console from the treadmill and remove the back
remove and replace the ribbon cables that run from the keypads to the control board (they are flat plastic strips that push into the board).
remove and replace all the connections on the console
reattach the console and calibrate by doing the following:
1. With the key off press the speed + and stop buttons at the same time and hold
2. place the key on and release the buttons
3. press the stop key once
4. press the speed up til it reaches 85
5. if your max speed is 10 mph then it should read about 9.8-10.2

If the keys will not work then the console is bad and would need replaced.

console is bad no other alternative, check ebay for part

You should have a speed arrow up & down, this increases and decreases the speed in .1 mph. Try this control and see how the unit re-acts if the speed does not adjust in .1 mph increments or it stay the same either way it sounds like an upper board issue. Go to iconfitness.com go to customer service the replacement parts put you M# and will give part# and pricing.
RULE OF THUMB: IF REPAIR IS MORE THAN THE THE PURCHASE PRICE OF UNIT DOE NOT REPAIR

OK, this is what you do: 1. Make sure your Jabra VBT 2050 is fully charged. 2. Enable bluetooth on your phone. 3. Turn on your VBT 2050 with the little button on the side (the white light between the keys should flash). 4. Initiate a search from your phone while holding down the center button on the VBT 2050 (middle, under the + and -). 5. You might need to do another bluetooth search using your phone (it took me about 4 times befor my Blackberry Storm picked up the signal. 6. When your phone asks for a code, type in 0000 (the default number).