Why does my fit bit keep lighting up every minute

You can carry it in a pocket until you order a replacement band from Fit-Bit or Amazon. I will still log steps accurately, provided you keep it apart from other devices. It won't, however keep accurate heart rate, or sleep measurements. I hope this helps.

Need a little more info,
When your cluster dies, is it everything?
All back lighting? or just the icons don't light anymore?
How about outside lights? tail, brake, marker, head lights, are any of those out when the fuse blows?
Does the fuse blow right away or is it a slow few minutes to hours or days?

I did some checking on BMW X5, seems that this particular vehicle has major problems with everything, so this may take some time to get straightened out.

is there is a coolant or not.

Hi
have a look inside where the bulb fits in to the cluster it may need rubbing with a bit of sand paper or lightly scraping with a flat screwdriver as the electrodes turn green after time where the bulb makes connection to the cluster
Hope this helps Nick

could be warped brake disk if its got too hot anytime

here's a way to check for leaks assuming your not in minnesota and its 30 below zero.
Fill a spray water bottle with water and then put a teaspoon of soap in the bottle..shake.
Squirt the soapy water onto the air fittings to test for leaks. If the fitting bubbles up, then you have a leak. In that case, tighten the fitting with a wrench, or remove and reinstall the fitting with thread sealant.
Undo the fitting with a wrench. Apply two wraps of Teflon tape around the fitting, then tighten the fitting and test again.
If the fitting still leaks, you may have a cracked fitting. Replace the fitting and reinstall, then test again.
Hope this helps.

HI ,do this and it will light providing it has no faults ,turn your gas bottle on ,turn the gas dial a 1/4 around and press it in and hold it in for 2 minutes ,keep holding in and press the igniter to spark it ,if that doesnt work use a lighter ,when it lights keep the dial pressed in for 2 more minutes so it heats up a bit then you can turn it up hotter as you please and let the dial go ,THANKS FOR USING FixYa

I can at least point you in the direction of the instruction manual:
https://www.nintendo.com/consumer/manuals/wii.jsp

Hi, You don't say what the make or model is, so I will give you the best advice I can. Most motion sensor lights today have a switch or two on them for "on", "test" and then some time like 3 minutes, or 5 minutes. The switch is tiny so it or they are easy to overlook. The "on" position will keep the light on all of the time. The test position does different things on different models but you will want one of the time settings. If this doesn't work for you get back to me with a little more info and we'll keep on it. Good Luck!

The new screens being sold are for the Japanese model that is why they fit a bit differently. Also they are just not as bright. There is nothing you can do really to fix this. As you can see on your old screen there is a black frame around the screen, this helped to keep the light centered into the plastic over the LCD and make it brighter, the Japanese version doesn't have this. The LED used is also not as bright on the replacement screens.