My tom tom rider cnt find my cardo scala headset even tho it is on, can you solve, thanx

Dear Daniel this link will be help you about your query
http://www.reslers.de/Cardo/

All I did was clear it from the phone and made sure I had a full charge on my scala. Then I just reconnected it. That was it. Once I had made sure I had the full charge that was it.. Done. Hope this helped. Regards, Denise

give it back. I also have problems with my Scala rider Q1 system. I would not pay R 200 FOR THIS TYPE OF RECEPTION and i have payed R3000. Bad deal.

Cardo had a problem in the firmware of the early models that caused the auto adjust on the volume to overload the speakers. Not knowing how old your unit is I have no way of knowing if this is the problem. If you still have the units you can buy new audio bases. I also have a source for replacement batteries.

I can fix it...

ipod 5th generation battery fits, not the ipod video

I am having the same problem. Did you ever find the solution?

Guys, if you roll out a device that can detect the battery if you own a soldering iron it can be easily replaced by a similar or even greater capacity.

I had a similar problem when I first connected my Cardo Scala Rider set to the helmet. First off, make sure that the volume on the Zumo is set to 100% for BOTH guidance and mp3 functions. Then click the upper control on the Cado Scala to maximize the volume of the headset. When you've accomplished those two electronic hurdles, adjust the location of the speakers in the helmet - if location of the speakers is not optimized nothing you do with the electronics will have much effect. I typically run the mp3 volume at 20% and the GPS at 50% with the headset volume at halfway. My Cardo Scala unit is a Teamset and I sometimes have problems hearing my rider scream that I'm going too fast. I haven't bothered yet to tell her to keep the microphone closer to her lips.