Question about Watches
Would love to know how to open the Red Flash cover that spins freely . Can't figure it out
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: watch 3 dials inside face
so its a chrono watch i belive. well sometimes diffrent models require diffrent operations to set up the display.
Perhaps the manual can be found on the internet site of the watches brand.
Posted on Mar 18, 2008
Hello decksrnice & Guest, The battery should face 'IN' when placing in watch. The smaller size of the watch is the face. For Guest there is a flat type spring on the cover, carefully bend the spring to apply more pressure to the battery. Use a pencile eraser to clean the area the battery makes contact. If you bend the flat spring too far IT WILL BREAK.
Posted on Nov 05, 2008
do you have the button on your watch named "el" its the top left one, press and hold it for 3 secs. after you can change the time. you can press the mode button to change it :)
Posted on Jan 18, 2009
SOURCE: no watch setting directions
Some of the inexpensive watches like to mimic the expensive watches and put fake dials on the face of the watch. That way you get a Breitling look alike at the price of a Timex. If there don't appear to be controls for the dials, chances are that they aren't real dials, Look closely.
Posted on Jun 15, 2009
Invicta watches either have screws or push pins. The one I sized yesterday had screws; it was tricky because I had to hold a flat head screwdriver on one side of the pin and then another screwdriver on the either side to unscrew it (this kept it from just spinning without loosening). If it is a push pin (you will know by looking because either a screwdriver will fit in the head or not) then you will need to get a thin steel rod about the width of a paperclip, a hammer, and a block that you can support the watch on. Push pins are pressure set and you just have to tap them out with a hammer by hitting the pin pusher/ steel rod into the pin hole to knock it out. Knock out the pins to the links you want to remove and then use a pin to resecure your watch band together.
Posted on Oct 21, 2009
Tips for a great answer:
Feb 08, 2018 | Watches
Jan 07, 2018 | The Watches
Nov 05, 2017 | Watches
Mar 20, 2017 | The Watches
Aug 24, 2015 | ACCUTIME WATCH CORP. ACIME Round Dial...
Jan 03, 2015 | Watches
Dec 07, 2014 | ACCUTIME WATCH CORP. Frenzy Ladies Watch...
Jun 14, 2009 | Watches
25 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: