Console shows "hello" and buttons beep but nothing happens. Brand new unit, connections have been verified
Als je een energieneutraal huis laat bouwen, dan heb je daar als bewoner dagelijks profijt van. Jouw huis heeft namelijk geen externe energie meer nodig voor de verwarming, de koeling en het warmwater. De energie die daarvoor nodig is, wordt opgewerkt door bijvoorbeeld zonnepanelen. Zulke energiebesparingsmaatregelen leveren dus belangrijke voordelen op. Niet alleen voor het milieu en voor het verminderen van de CO2-uitstoot, maar ook voor je portemonnee. Want als je minder energie verbruikt, merk je dat direct aan je energierekening. Tel uit je winst. WAAROM EEN ENERGIENEUTRAAL HUIS BOUWEN?
Wow, this is really interesting reading. I am glad I found this and got to read it. Great job on this content. I like it. IRISH DRIVING PERMIT
×
SOURCE: Won't power on
sounds like it's showing a bad power situation...maybe the outlet is not too good?
SOURCE: Kenmore Elite HE4 beeps three times when start panel is pressed and wont turn on
FWIW ... the Sears guy came by yesterday. The problem was apparently that the door latch was not operating to the extent that the sensors thought the door was open. He is replacing the latch next week. He adjusted the old one in the mean tiome and it appears to be working fine.
This kind of stunned me, since my wife reported an electric zap and the interior light burned out as the dryer went dead -- so I was sure it would be a fried circuit board -- but, no, a little jiggling of the latch seemed to clear it up....
SOURCE: psyclone essentials ps3 wirless remote controller wont connect
just fixed mine. i went to psclones web site ...it doesn't even have the PS3 remote listed a s a product!! however by reading the PS2 manual i figured that if I basically adapted the instructions it might help...I moved the remote to the 3rd slot.. turned off controller switch... held connect button on reciever... turned on controller.... held connect button....held select button ......held down left analogue stick....in no particular order...going back and forth until i noticed the lights had started to go steady... kept holding (30 secs+) Saw a single steady red on 3rd slot...It stayed...Yeh ;O (no clue what was the deciding factor...but theres hope!!) Lesson learned..next time i pay the full price for the Sony remote... Hope this helps
SOURCE: Nordictrack motor will not run when start button is pushed.
Likely the cover of one of the motor brushes popped off. Unplug the machine before you pop it back in place, then try it again.
If that doesn't work, most likely it's the motor control board, or possibly the console, or finally just a loose connection behind the console.
But most likely, it's the motor brush cover. I've been seeing that alot with this model.
SOURCE: belt wont start on a brand new Sole F80. Motor
It sound like the motor control board is the culprit. Unplug unit then remove shroud then find the 2 leads that connects the motor to the motor control board disconnect them then plug in unit and see if the display blackout after programing the display then hitting start.
153 views
Usually answered in minutes!
×