Start butto not working on bizhub 423 - bizhub Konica Minolta Office Equipment & Supplies

If the red light is blinking on your Konica Bizhub 423, it usually indicates an error or issue with the printer. Here are a few things you can try to resolve the issue:

1. Check the display panel: The display panel on the printer should show an error message or code indicating what the issue is. Check the manual or contact Konica Minolta support to find out what the error code means.
2. Restart the printer: Try turning off the printer, unplugging it from the power source, waiting for a minute or so, and then plugging it back in and turning it on.
3. Check the toner: If the toner is low or empty, the printer may not function properly. Check the toner levels and replace the toner cartridge if necessary.
4. Check for paper jams: Paper jams can cause the printer to stop working. Check the printer for any stuck paper and remove it carefully.

If none of the above steps work, you may need to contact Konica Minolta support for further assistance.

did you replace the transfer roller sponge looking roller on the right side door. was the new image unit replace with a new drum and developer and where there the proper tests done after installing in along with clearing the proper counters

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

The only way to clear that is to install the movie data in service mode. It doesn't affect the functionality of the copier. It just won't show you step by step guidance on how to clear paper jam etc.

Go to cofiguration settings, scroll up/down to see the item you want to make changes.

Fatal Error C1004

try a different file. try a different program pdf, word, web page email does this happen with all of the them check your printer properties,

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

which ones

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

id someone leave a trash can or boxes under the output trays? To solve this problem requires removal of the rear cover of the finisher. Then remove the elevation drive motor assemble. Be careful don't want the output trays to fall!!!!!! Then while placing them in their proper position re seat the drive assy. The top tray should be just below the orange rollers (If they are cleaned) you will see several actuators the trays has to just touch them.

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

Type "Bizhub 423 user manual" into search engine. It will show sites to get manual.

my copise xerox work center pro 423 are showing on display this error (u4-6 @ reboot) how i can clear this error please tell me