Question about Power Acoustik Car Audio & Video

1 Answer

Trying to find out what resistors I need to get to replace the 2 that are bad in a Power Acoustik OVN1-2000D 2000W Max, Class D Monoblock Gothic Series Amplifier

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Novelist:

    An expert who has written 50 answers of more than 400 characters.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 79 Answers

Search google for a schematic should be able to find one. I repair amps. Marks Car Audio & Amp repair
e-mail skinnman33 @gmail.com I can be reached at 727-266-6398 Let me know

Posted on Apr 01, 2019

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
techman
  • 3130 Answers

SOURCE: Need a power connector for a Boss IQ 3KD.1 amplifier

Contact www.bossaudio.com

Posted on Mar 31, 2006

  • 5 Answers

SOURCE: 600 watt 2 channel power acoustik sterling amp

On your amp, there should be a switch (on the side probably) that has "LP", "HP", and "FULL" or "OFF". This is a switch for the low pass/high pass filter. Switch it to "LP" as this will allow only low frequencies to go to your subs, what you want. If you don't have that switch, go to an audio store or online audio supplier and get either a low pass filter, band pass filter, or a cross-over, and follow the wiring diagram that comes with it to filter out the high frequencies before they get to your subs.

Posted on Oct 09, 2007

  • 631 Answers

SOURCE: Power Acoustik G320-2 Gothic Series

If you're geting no lights on the amp, you need to confirm that you have voltage at the amp. If you haven't done so yet, check the on-board fuses.

With your multimeter set to DC volts, the black meter lead on the ground terminal of the amp (not on the point where the ground wire connected to the vehicle) and the head unit on (so the amp will have remote voltage applied), touch the red lead alternately to the B+ and remote terminals of the amp. If the voltage is below ~11 volts, you need to check the wiring feeding whichever line is too low.

Posted on May 10, 2008

blueextc3221
  • 15935 Answers

SOURCE: ICBM-DIGITAL MONO-Channel 2000W AMPLIFIER speaker much

Look into competition lines of different manufacturers.... Massive Audio DMX, Soundstream, Atomic APX, Incriminator Audio Death Penalty Series, Kicker Solo X etc. In car audio, you have to pay to play. Dont expect a 100.00 subwoofer to take 2000W continuously.
Massive Audio offers a no questions asked warranty. Even covers blown voicecoils!

Posted on Dec 22, 2008

etirbynnor
  • 655 Answers

SOURCE: How do i wire two 15 inch subs to 2 ohms

Hello familia_gome,

Those MOFO-15's have dual 1ω voice coils. So the only way you can get 2 of them to present a 2ω load is to use 1 voice coil on each one with the two of them wired in series. Using both voice coils, you can get a 1/4ω load by wiring the voice coils in parallel and then wiring the subs themselves in parallel. You'll get a 1ω load with the voice coils in series and then parallel the subs. Or you'll get a 4ω load with both the voice coils and the subs in series.

Here's a link to Power Acoustik's PDF for the MOFO's. I recommend that you check out the wiring diagrams on page 3.

http://www.poweracoustik.com/SUPPORT/MANUALS/PA-MOFOWoofer.pdf

Hope this helps.

Posted on Apr 07, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2000w TNT amp blows fuses as sooooon as I put a fuse in. What is the problem with the amp. is it internal external? I also checked my wires and they all look good


Sounds like you're grounded out somewhere. I'd check your main power wire again, make sure there isn't any abrasions or cracks in the insulation. I had a Fosgate amp that would blow fuses everytime they were put in. turned out to be one of the screws to mount the amp to my floor board was grounding it out, pulled the screws and has worked fine ever since

May 04, 2012 | Alpine Earthquake T2000wd/1 Car Amplifier...

1 Answer

I have a power acoustik 0v2-300 2 channel amp i just wanna know can i bridge it


Most amps will show right on the amp by the speaker wire terminals if it is bridgeable.
Good luck !

Jan 28, 2010 | Power Acoustik GOTHIC OV2-300 Car Audio...

1 Answer

How to bridge a 4ch power acoustik amp to 2ch


I had the Power acoustik saphire 4ch and had to do the same thing. Use the Positive from Term1 (spkr1) and Negative from Term2(spkr2). Good Luck.

Nov 26, 2009 | Power Acoustik GOTHIC OV4-800 Car Audio...

1 Answer

Power acoustik gothic OV2 800 manual


Could not get a manual for you but did get the follwing specs. Hope they help.

Power Acoustik Ov2-800 2-Channel Class A/B Gothic Series Amplifier (800-Watt)
POWER ACOUSTIK OV2-800 2-CHANNEL CLASS A/B GOTHIC SERIES AMPLIFIER

800-WATT 2-CHANNEL
4 ohm RMS: 150W X 2
2 ohm RMS: 180W X 2
Bridged mode MONO RMS: 360W
BRIDGED MAX: 800W
FULL MOSFET POWER SUPPLY
PWM CIRCUITRY
FULL SELECTABLE CROSSOVER
3-WAY PROTECTION CIRCUIT
TRI-MODE CAPABLE
VARIABLE LOW PASS 40 HZ - 120 HZ
VARIABLE HIGH PASS 150 HZ - 1.5 KHZ
VARIABLE 18 DB BASS BOOST @ 40 HZ
FREQ RESP: 10 HZ TO 30 KHZ
S/N RATIO: 98 DB
THD: 0.02%
2 ohm STABLE STEREO
SYSTEM DISTRESS INDICATOR
HIGH/LOW LEVEL INPUTS WITH FLOATING GROUND
4-GAUGE POWER/GROUND CONNECTION
PLATINUM RCA CONNECTORS
LINE OUTPUT WITH FLOATING GROUND

BLUE LED
CHROME TOP PLATE PANEL 2-CHANNEL CLASS A/B GOTHIC SERIES AMPLIFIER (800-WATT)

Aug 18, 2009 | Power Acoustik GOTHIC OV2-800 Car Audio...

1 Answer

My amp is flashing in and out of protect


you must likey just fryed the wires, try putting in bigger fuses, and unhooking everything and re hooking it up

Jun 13, 2009 | Power Acoustik GOTHIC OV2-1800 Car Amp

1 Answer

Trying to figure out what kind of amp i got amercian pro vs-3507?


The VS3507 Is a class D monoblock.
Your optimum wiring for this amplifier is a 2 Ohm load - so it produces its full potential power of 350W RMS.

To Achieve a 2 ohm load, the most common load is one of the following...
(1) Dual 4 Ohm Voicecoil Subwoofer Wired in Parallel.
(2) 4 Ohm Voicecoil Subwoofers wired in Parallel.
(1) Quad 2 Ohm Voicecoil Subwoofer wired in Parallel/Series.
(1) Single 2 Ohm voicecoil subwoofer.

American Pro VS3507 2000W Car Audio Monoblock Amplifier
American Pro VS3507 Monoblock Amplifier Details
  • Built-In Crossover
  • Variable High/Low Pass Filters
  • Phase Shift Control
  • Subsonic Filter
  • Bass Boost Control
  • Dancing Lights at the Rhythm of Music
  • Protection Circuits
  • Gold Plated Terminals
  • Power & Protection Circuit LED
  • 1 x 250 Watts RMS @ 4 Ohms
  • 1 x 350 Watts RMS @ 2 Ohms Thanks for using FixYa - A FixYa rating is appreciated!!

Jan 29, 2009 | American Pro Car Audio & Video

1 Answer

Power acoustik gothic ov2-1600


What are the circuit board designations (Q111, Q112, Q211, Q212...) for the parts you replaced?

Did you replace the defective parts with identical transistors?

Which transistors are heating up?

Nov 07, 2008 | Power Acoustik GOTHIC OV2-1200 Car Audio...

1 Answer

Power Acoustik


the amp shouldnt even lite up w/o the ground attached.

Jan 25, 2007 | Power Acoustik GOTHIC OV2-520 Car Audio...

Not finding what you are looking for?
Car Audio & Video Logo

Related Topics:

42 people viewed this question

Ask a Question

Usually answered in minutes!

Top Power Acoustik Car Audio & Video Experts

Dalynn Turner

Level 2 Expert

346 Answers

Marvin
Marvin

Level 3 Expert

85020 Answers

Professor_V
Professor_V

Level 2 Expert

93 Answers

Are you a Power Acoustik Car Audio and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...