Impuse treadmill with err 94? - Exercise & Fitness

Try this:
Switch the treadmill off and then on again.
Push the "minus" speed button and the "stop" button simultanuously.

If all is well you will now have entered the maintenance mode.

Next push the "plus" speed button and the "stop"button smultanuously.
Now you've reached the error mode.

Push the "plus" or "minus" speed button to browse the error codes untill you've reached "L er".
The push start to erase the message.

Turn the power off and then on again to restart the treadmill.

With any luck the error has disappeared and the treadmill will function again. If not.....you'll have to contact Kettler.

Switch the treadmill off and then on again.
Push the "minus" speed button and the "stop" button simultanuously.

If all is well you will now have entered the maintenance mode.

Next push the "plus" speed button and the "stop"button smultanuously.
Now you've reached the error mode.

Push the "plus" or "minus" speed button to browse the error codes untill you've reached "L er".
The push start to erase the message.

Turn the power off and then on again to restart the treadmill.

With any luck the error has disappeared and the treadmill will function again. If not.....you'll have to contact Kettler.

main computer is fried

Here the complete pdf user manual for it
http://www.bhfitnessusa.com/manuals/final/t8sport.pdf

Tony

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/tony_a41fa0b801734e2f

ERR E-7 indicates that the DC incline motor and the variable resistor (VR) are not synchronized. Signal from the VR is not being received properly. Mechanical and/or electrical calibration is needed to reset this error message.

http://www.sportsartamerica.com/SAF/support/technicalsupport/techtips/Treadmills/DC_Incline_Calibration.pdf?utm_source=fixya&utm_medium=cpc&utm_campaign=mendi

This is probably a 1) faulty speed sensor or
2)the speed sensor is not plugged in properly.
3)Its also possibly a faulty motor control board or
4) lower board. T
he error codes will differ between makes and models but could be e1.
However if you send the complete information, if can not fix you treadmill, how model, mark, serial number, I can handle more specific.
sincerely.
E.CUADRA
MANAGUA, NICARAGUA. C.A

Please LUBE the Treadmill.
How To Lubricate Treadmill
Blessing
[email protected]
cell+whatsAPP:+50588611441

hi,
check the speed sensor near the motor pulley. if the sensor is open this problem can occur.
ok

Err 1 displays after working for approx 1 minute

Hi Rendra,

Try this:
Switch the treadmill off and then on again.
Push the "minus" speed button and the "stop" button simultanuously.

If all is well you will now have entered the maintenance mode.

Next push the "plus" speed button and the "stop"button smultanuously.
Now you you've reached the error mode.

Push the "plus" or "minus" speed button to browse the error codes untill you've reached "L er".
The push start to erase the message.

Turn the power off and then on again to restart the treadmill.

With any luck the error has disappeared and the treadmill will function again. If not.....you'll have to contact Kettler.

Btw...This error occurs when the belt is "pushed" by the runner. For example when you put weight on the handlebar and the push your feet backwards.