Why can't I reset my sony bt auto radio with pinhole.

so what makes you think the laptop has BT?
its and option on all PC made, when new (check this first)

is this the only BT device you own? do tell.
and can be added to any PC on earth with a BT USB dongle stick.
for like $4
what is the distance to the speakers (BT uses radio signals weak)
10ft 50 ft (10 meters) what? distance matters on all transmitters regardless if BT, wifi, wlan, or 3g/4g/. etc...

BT comes in 2 power settings, some devices do not use high power mode. (on speakers this would make for best)
does the speakers pair with any other PC? with BT?

the speakers if not junk has RTM manual. and read the page on
how to reset pairing.
BT loves to memorize your favorite devices, so if problems happen.
learn how to reset that memory , call reset pairing history.

Check to see if there is a tiny pinhole to stick a paper clip into to reset the radio.

I am not real sure about the Sony Walkman but most of the MP3's I have owned have a pinhole that can be used to reset your player, If yours has the pinhole you can take a small needle and put it in and it will reset it, I have had to do it because of a corrupt file was causing me problems and the reset repaired the problem. Also have you looked in your history folder on your computer for the website you are searching for?

Have you tried resetting the microprocessor?

Remove the detachable face. There is a small pinhole on the front of the radio about two inches from the left side near the bottom. Press this in lightly with a fine point pin or paper clip. Hold about 3 seconds, then release.

Replace the face and try it. Let me know.

Reset the microprocessor. It should be a pinhole, probably on the front panel behind the face. Use a sharp ball point pen or paper clip.

If this doesn't cure it, the radio (likely the face) is bad.

This is easily fixed. Set the time manually the 1st time. Make sure you use the CORRECT time, which is four minutes less than what the clock said when you first plugged it in. Once you reset the timing, it will remember the four minute difference and always show the correct time.

make sure wireless channel number should be the same on BT hub and on belkin. BT hub is normally on Auto channel change it to a channel number usually 1 and 11 are the best for coverage and then chose the same channel number in belkin.

Go into the menu and scroll to "reset" and follow the on-screen instructions.

Ok, I have a Sony MEX BT 2600. To pair my phone to the radio, I had to press and hold the BT button for 5 seconds until it flashes, then I have to search for devices on my phone. Xplod comes up. When it does, pair the two and use code 0000. That should do it. Also make sure the BT icon is showing, meaning it is activated for the Sony to connect. When conncted, the radio should show a phone icon for the BT Phone segment of the radio, and then another icon for the BT Audio, both should what looks like radio waves coming off of them, meaning the two devices are connected and recognizing each other.

I think your problem is in tuner stage.

1. Check 32V dc available on BT connection on tuner.
2.If 32V available on BT,connect dc meter and put the unit on auto search and check the BT pin on tuner.The BT voltage will decrease and increase while it tunes.
3.If nothing stored after programming replace tuner.


Good luck
Dals123